electrolux use 9
In both cases the Start/Pause button flashes to remind you that the start button needs to be pressed again.
Indicator lights
These lights indicate the following functions:
Drying light
This light indicates that the appliance is in the drying phase.
Cooling light
This light indicates that the appliance is in the cooling phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry.
End/Anticrease light
This light is on at the end of the cooling phase, DURINGåTHEåANTICREASINGåPHASEåANDåATåTHEåENDå of the program.
Condenser light
It comes on every 80 cycles to remind you that the condenser must be cleaned.
Filter light
This light illuminates at the end of the program to remind you that the filters must be cleaned.
Water Tank light
This light comes on at the end of the program to remind you that the water tank must be emptied out. If this light illuminates during a program this means that the water tankis full. The buzzer sounds, the program stops, the Start/Pause button flashes. This light comes on also when the water tank is not inserted correctly.
At the end of the program
All drying programs end with a 10 minute cooling phase.
You may remove the laundry after this phase. The lights 
Filter and 
Water Tank illuminate. The display shows a static zero.
If the laundry is not removed at the end of
the cycle, the dryer performs an anticreasing phase (duration: 30 minutes maximum). If you do not remove the laundry, the dryer will stop AUTOMATICALLYåATåTHEåENDåOFåTHEåANTICREASINGå phase. Lights 
Filter and 
Water Tank remain lit and the buzzer sounds for 2 minutes.
Turn the program selector dial to “O” to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty.
If you open and then close the door before turning the selector dial to “O” all the lights corresponding to the phases making up the performed program come on.
After each use
så #LEANåTHEålLTERSå
så %MPTYåTHEåWATERåTANKå
Modifying the program
To change a program which is running, first cancel it by turning the program selector dial to “O”. Select the new program and press the Start button .