Estate Clothes Dryer warranty ‘ri\Belt, Warnlng, View B

tf your dryer Is gas and has a full front panel, remove front panel as follows

1. Unplug the power supply cord or turn off the
electrical	power.
2. Open lint screen lid. Remove two screws
from lint	screen area.
3. Open top by pulling forward and up at each
front comer (see View A). Rest raised top
against wall behind dryer (top is hinged
at rear).
4. Remove two internal screws from front
panel flanges (near top front corners). Lift
front panel slightly, lifting off lower clips (see
View B). Slowly pull front panel forward,

da

Remove screw6 before opening top

disengaging		panel from drum. (Drum will
drop	slightly.)
5. Move front panel aside and rest edge
against side of dryer. Avoid disconnecting
wire clips (see View C) or damaging wires.
6. Remove lint from area shown in “gas dryer”
illustration on page 10 with soft brush or
vacuum cleaner. Avoid damaging wires,
funnel	or ignitor.
7. Reassemble		in reverse order. Before
closing the top, check the following:
-Drum seal must be flared out (see View
D) and properly positioned against panel
at back of drum. Rotate drum counter-
clockwise one full turn to check drum seal.

-Belt should be centered and tight on dryer drum.

-Wire clips which hold the door switch wires must be anchored in slot in top of front panel (see View C) and along top edge of side panel. Door wires must not touch drum when dryer is operating. See

Warnlng, page 10.

8.Replace top panel and lint screen screws. Top and front panels must be securely in place before operating dryer.

9.Reconnect power and level dryer again (if necessary).

NOTE: Call our toll-free number l-800-253-1 301, for assistance or more information.

View	A
Drum seal	Side panel
	sire clips	Front panel
		wire	clip
		(see View	C)

\\‘ri\Belt

Wire clip-holds door switch wires

\

View B View C

11