Blomberg TKF 7330 A manual Maintenance and cleaning, Cover filter

For Filter cleaning;

1Take out the cover

2Lift the Cover filter up to pull out.

3Clean lint, fibre, and cotton raveling by hand or with a soft piece of cloth.

4Place the filter back into its place.

For the condenser (products equipped with a condenser);

Hot and humid air in the condenser is cooled with the cold air from the room. Thus, the humid air circulating in your machine is condensed and then pumped into the tank.

CClean the condenser after every 20 drying cycles or once a month.

To clean the condenser;

1If a drying process has been carried out, open the door of the machine and wait until it cools down.

2Unlock the 3 condenser locks after opening the kick plate.

3Pull out the condenser.

4Clean the condenser with pressurized water and wait until the water drains.

5Replace the condenser with the side labeled "Top" facing upwards. Lock the 3 condenser locks.

6Close the kick plate cover.

Filter drawer (for products equipped with a heat pump)

Lint and fibre that could not be caught by the cover filter are blocked in the filter drawer behind the kick plate. “Condenser cleaning” warning light will light up periodically after a maximum 5 drying cycles as a reminder.

In order to get the best performance from

your machine, clean the cover filter and the filter drawer after each drying cycle. There is a two-phase filter in the drawer. The first phase is the cover filter and the second