Blomberg TKF 7330 A manual General Safety, First Use, Intended use, Safety instructions

Page 6

2Warnings

Please read the following information. Otherwise, there may be the risk of personal injury or material damage. Moreover, any warranty and reliability commitment will become void.

General Safety

Never place your machine on a carpet covered floor. Otherwise, lack of airflow from below of your machine may cause electrical parts to overheat. This may cause problems with your machine.

If the power cable or mains plug is damaged you must call Authorized Service for repair.

Your washing machine is designed to stop operating in the event of power resuming after a power failure. Press Start/Pause/Cancel button to resume the program. Press the “Start/Pause/

Cancel” button for 3 seconds to cancel the program. (see, Canceling a

Program) (see, Canceling a Program)

Your machine can be operated at temperatures between +5°C and +35°C.

First Use

Current value of the fuse at your home must conform to the current value of the machine indicated on the

“technical specifications table”.

Do not neglect to have the grounding installation made by a qualified electrician. Our company shall not be liable for any damages that may arise when the machine is used on a line without grounding.

Please call the Authorized Service to commission your machine.

When operating your machine for the first time, partly load it with wet pieces of clothes and let it run approximately for 15 minutes.

You may smell an unpleasant odor and excessive fibre/lint may accumulate during first drying cycle.

For safety and performance purposes, clean the filters after each drying cycle.

Intended use

This product has been designed for home use.

The appliance may only be used for drying of textiles that are marked accordingly.

Please follow the maintenance and care instructions given on the textile labels.

Safety instructions

This appliance must be connected to an earthed outlet protected by a fuse of suitable capacity.

Unplug the machine when it is not in use.

Never wash down the appliance with water! There is the risk of electric shock! Always disconnect from the mains by unplugging before cleaning.

Never touch the plug with wet hands.

Never unplug by pulling on the cable, always pull out from the plug only. Do not operate the machine if the power cord or plug is damaged.

Never attempt to repair the machine yourself. Otherwise, you may be putting yours and other's lives in danger.

For malfunctions that cannot be solved by information in the operating manual: Turn off and unplug the appliance and call an authorized service agent.

Do not use your dryer to dry garments that were dry-cleaned or processed with stain removers. Vapors from the material may be combustible, poisonous and explosive. It may harm you or damage your machine.

If there are children in your

house...

Electrical appliances may be dangerous for the children. Keep children away from the machine when it is operating. Do not let them tamper with the machine.

Close the loading door when you leave the area where the machine is located.

5 - EN

Image 6 Contents
TKF 7330 a Explanation of symbols Please read this manual firstTable of Contents Your Dryer OverviewTechnical Specifications First Use General SafetySafety instructions Intended useUnder Counter Installation InstallationAppropriate installation location Adjusting the feetPage Electrical connection Destroying the packaging materialDisposing of the old machine Preparing clothes to be dried Initial preparations for dryingGarments suitable for drying in the machine Correct load capacity1500 Home articles Approximate Weights grLoading door 1000Turning the machine on Selecting a program and operating your machineControl panel Program selectionTimer programs Program selection and consumption table Time delay Auxiliary functionStarting the Program Progress of programChanging the program after the program has started Ending the program through canceling Child-proof lockEnd of program For the condenser products equipped with a condenser Maintenance and cleaningCover filter Filter drawer for products equipped with a heat pumpCondenser sponge for products equipped with a heat pump Sensor and drum fin Solution suggestions for problems Problem Cause Explanation / SuggestionPage Page Symbole Bitte lesen Sie dieses Dokument zuerstDiese Bedienungsanleitung Warnhinweise Lösungsvorschläge bei ProblemenIhr Trockner Vorbereitungen vor dem Trocknen9Ihr Trockner ÜberblickTechnische Daten Warnhinweise Aufstellung auf einer Waschmaschine UntertischinstallationDer richtige Aufstellungsort Füße einstellenEnde jedes Programms auf Wichtig Kann es zu unkontrollierter Verbrennung kommenAnschluss der Maschine an Achten Sie gut darauf, den SchlauchElektrischer Anschluss Verpackungsmaterial entsorgenAltgeräteentsorgung Textilien zum Trocknen vorbereiten Vorbereitungen vor dem TrocknenTrockner-geeignete Textilien Die richtige WäschemengeTür Nachfolgend finden Sie einige GewichtsbeispieleProgrammauswahl BedienfeldMaschine einschalten Das Programm mit der Start/Pause Abbrechen-TasteTimerprogramme können 10, 20, 40 und Mit diesem Programm können SieProgrammauswahl- und Verbrauchstabelle SynthetikfasernHinweisanzeigen „Lösungsvorschläge bei Problemen nachZusatzfunktionen ZeitverzögerungProgramm starten ProgrammfortschrittProgramm nach Programmstart ändern Programmende KindersicherungWaschprogramm abbrechen Abschluss des Programms nicht gleich HerausnehmenWartung und Reinigung Faserreste in den Poren zurückbleiben Dies ist in Ordnung Kondensatorschwamm bei Produkten mit WärmepumpeNehmen Sie den Filterschwamm heraus KunststoffrahmenÖffnen Sie den Deckel der Maschine Sensor und TrommelflügelWassertank bei Produkten mit Kondensator und Wärmepumpe Reinigen Sie die Metallsensoren viermal pro JahrLösungsvorschläge bei Problemen