Bosch Appliances V20-UL manual Operation, Using the dryer

Operation

Using the dryer

1. Open the door.

4.If required, selectDelicates low temp. by pressing the button.

See explanation on page 15.

7.Press theStart/Stop button. The Start/Stop indicator light illuminates.

If an automatic program has been selected, the indicator lights indicate the progress of the program sequence.

iAt the end of the program sequence Damp dry is emitted (if set).

2.Check lint filter.

The filter should be cleaned after and before every drying process. Cleaning the filter reduces the drying time and saves energy.

3.Rotate program selector to the desired program.

Select the program which corresponds to the laundry in the dryer from the program

selection table (see page 22). The Start/Stop indicator light starts flashing.

i	Lint filter	indicator flashes for
	5 seconds	- Check lint filter!

16

5. Place laundry in			the empty
drum. Put each piece of laundry
into	the	machine	separately.
For	best	results	the laundry	to
be dried must be sorted
according to type of laundry
and desired degree of drying.
For	further information see			i At program end the LED

	page 14.							Wrinkle	block/End illuminates.
							i	When the		drying	process is
i	Observe		drying	symbols of		the
								complete		(program	or selected
	laundry	manufacturer.
								time program ended), the drum
Ensure that			there	is only	laundry in			rotates	at	specific	intervals.
the	drum.	Check		that all	items	are		This prevent the laundry from
completely		in	the	drum.				creasing.
6. Close		the door.					8.	Open the		door.

iIf the door has not been closed 9. Take the laundry out of the properly, the dryer will not start. dryer.

10.Rotate the program selector to Off.

The dryer light goes out.

11.Clean the filter.

The filter should be cleaned after each drying process. Cleaning the filter reduces the drying time and saves energy.

12.Close the door.