7Maintenance and cleaning
Filter Cartridge / Door Inner Surface
Lint and fibres released from the laundry to the air during the drying cycle are collected in the “Filter Cartridge”.
CSuch fibre and lint are generally formed during wearing and washing.
CAlways clean the filter and the inner surfaces of the cover after each drying process.
CYou can clean the filter and filter area by vacuum cleaner.
To clean the filter:
1.Open the loading door.
2.Remove the cover filter by pulling it up and open the filter.
3.Clean lint, fibre, and cotton raveling by hand or with a soft piece of cloth.
4.Close the filter and place it back into its seat.
C Clogging may arise on the filter surface after using your machine for some time; if this occurs, wash the filter with water and dry it before using again.
C Clean the entire inner surface of the cover and door gasket.
Sensor |
There are humidity sensors in your dryer that detect whether the laundry is dry or not.
To clean the sensor:
1.Open the loading door of the dryer.
2.Allow the machine to cool down if drying has been carried out.
3.Wipe the metal sensors with a soft cloth, dampened with vinegar and dry them.
CClean metal sensors 4 times a year. A Never use solvents, cleaning agents or similar substances when cleaning
since these materials can cause fire and explosion!
Water tank;
The moisture in the damp laundry is taken from the laundry and condens ed. Drain the water tank after each drying cycle or during drying when “Water tank” warning light turns on.
A Condensed water is not drinkable!
A Never take out the water tank when the programme is running!
- Inside the drawer on the panel - Behind the kick plate cover
If you forget to drain the water tank, your dryer will stop during the following drying cycles when the water tank is full and the “Water tank” warning light will turn on. If this is the case, press the “Start/Pause/Cancel” button to resume the drying cycle after draining the water tank.
To drain the water tank:
1. Drain the water as shown on the picture .
23
EN