Using Method
4. Set 'heat selector knob' to select 'Strong dry' or 'Soft dry' level.
'Strong dry' level for large quantity and low room temperature.
' Soft dry' for non | Soft |
Strong | |
| Heat selector knob |
5. Dry time settings
Select dry program according to clothes materials and
quantity, turn the timer knob to relative position. TheDo not point the dryer starts running.
cursor to blank.
Please refer to page 8 ' Control panel and its functions' | Air drying 60 | OFF | Cooling | |||
and page 10 ' Dry Capacity Dry Time Reference Table' . | 0 | |||||
|
|
| ||||
40 |
|
| 20 | |||
|
|
|
| |||
Caution: Dry timing knob cursor |
| 20 |
|
| 40 | |
Do not |
|
|
| |||
|
|
| 60 | |||
shouldn't be set at the blank area, | point the OFF 0 |
|
|
| ||
as indicated in the right figure. | cursor to |
|
| 80 | ||
| blank | 220 |
|
| 100 | |
|
|
|
| |||
|
| 200 |
|
|
| |
|
| Strong dry | 180 |
| 120 | |
|
|
| 160 140 Regular dry | |||
Drying time(min)
6. Do not take the laundry out until drying process is done
The last 20 minutes of hot air drying is cooling to reduce the temperature of laundry inside the drum.
To take the laundry out during drying, please run cooling operation first since the temperature inside the drum must be high.
Static electricity, due to friction, will be 
generated on clothes made of chemical fibre after dried. You can feel it when taking them out, which is normal and shall not to be worried about.
7. Unplug the power cord
Please hold plug to unplug power cord from
a receptacle. Do not pull electrical wire directly to prevent internal breakage or bad connection.
8. Clean filters
Clean the lint filter after every load and before each use. A clean filter ensures sufficient drying. A layer of lint on the filter reduces airflow through the clothes and prolongs drying time
Refer to the instructions on page 11.