IMPORTANT
You must disconnect and lockout the electric supply and the gas supply or the steam supply before any covers or guards are removed from the machine to allow access for cleaning, adjusting, installation, or testing of any equipment per OSHA (Occupational Safety and Health Administration) standards.
Please observe all safety precautions displayed on the equipment and/or specified in the installation manual included with the dryer.
CAUTION
Dryer(s) should never be left unattended while in operation.
“Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper operation.”
«Attention: Lor des opérations d’entretien des commandes étiqueter tous fils avant de les déconnecter. Toute erreur de câblage peut étre une source de danger et de panne.»
WARNING
Children should not be allowed to play on or near the dryer(s). Children should be supervised if near dryer(s) in operation.
Under no circumstances should the dryer door switch(es), lint door/drawer switch(es), or heat safety circuit(s) ever be disabled.
The dryer must never be operated with any of the back guards, outer tops, or service panels removed. Personal injury or fire could result.
The dryer must never be operated without the lint filter/screen in place, even if an external lint collection system is used.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not use dryer in the presence of dry cleaning fumes.
The dryers must not be installed or stored in an area where it will be exposed to water and/or weather.
The wiring diagram for the dryer is located in the front electrical control box area.
Table of Contents |
|
Part Locations and Removal | 4 |
Lower Front Panel Removal | 4 |
Upper Front Panel Removal | 4 |
Top Cover Removal | 4 |
Middle Panel Removal | 4 |
Lint Box/Blower Assembly Removal | 5 |
Gas Valve/Ignition System Removal | 5 |
Oven Chamber Removal | 6 |
Gas Valve/Ignition System Components | 6 |
Oven Housing Components | 6 |
Tumbler Support |
|
Wheel Assembly Replacement | 6 |
Tumbler Alignment | 7 |
Belt Replacement | 8 |
Placing the Belt Back on the Motor Sheave | 8 |
Electrical Component Locations | 9 |
Electrical Panel | 9 |
Sail Switch and Axial Probe Assembly | 9 |
Exhaust Probe, Exhaust |
|
and Lint Drawer Switch | 9 |