Frigidaire 131888900 manual

Page 3

i:, Connecttilenine[)mplugremovedin step8tothe connectorboardontheadapterharn_:ss.

i_. Dresstheadapterharnessalongsideofthepresent washerharnessasshown¸

i?. Connect the green connccto_ plug ll-om lhe adapte_ harness to the pump. Re-install the pump cover, if it was removed in step !3.

I8. Connect the green connector phlg fiom the washer harness to the connector on the adapter harness.

19.NOTE: If the service kit's door lock is already pre- wired to the adapter harness, go to step 20. If the

service kit's door lock is not pre-wired to the adapter haHless, conned the adapter haraess connections to the new door lock

2(} Matching color [br color, connect the door switch wires fiom tile washe_ harness to the connectols m the adapter harness

21Install the new door lock to the washer cabinet using tile same screws removed in step 6

!!.Using the plastic harness ties, attach 1he adapter harness to the washer harness. Dress the hmness in such a manner that it will not interlierc with any moving parts or cause ally noise when die washer is m operation.

23. Connect the washer to the electrical power source and test for proper operation. Close the door, place Ibe iilnel to the final spin positioa, and start tile lilner. When the machine starts its tRst ramp up to tile higber spin speed, turn the tirner off; then quickly pul! on the door handle to verify the door is locked, lltlle door opens, recheck the connections in steps 9 through 12

24 Using the tube of adhesive, glue the bellows to tile

l}ont panel at the 2. 3, & 4 o'clock positions. Wait about two minutes, tllen pull on the bellow to make sure it is securely bonded to the flon! pane!.

2q Install the li-ont sel vice pntm!

Image 3
Contents 417/FRIGIDAIRE Front Load Washer Door Door LOCK/SWITCH KIT P/N Installation Instructions