Step 0 Select Control Dial Cycle
_TELL_R_
OFF MOREDRYREGULAR
,LESSORV
6o |
|
|
|
WRINKLE FREE MORDRYE | |
FA B RICS | |
. _ | /._;:: |
DAMP DRY |
|
DRYEL FABRIC CARE is designed for use on dry clean only fab- rics in combination with Dryel, a dry clean only fabric care prod- uct. Placing the control dial arrow at START will provide the optimal amount of time needed to properly use Dryel. (For more information on using the Dryel cycle, see page 7.)
WRINKLE RELEASE will release wrinkles from items that are
clean and dry but slightly wrinkled, such as from a crowded clos- et, packed suitcase or from sitting in the dryer too long after the end of the cycle. It provides 10 minutes of heated tumbling and 5 minutes of cool down tumbling without heat.
DAMP DRY is designed to "partially" dry items. It provides
approximately 20 minutes of heated tumbling and 5 minutes of cool down tumbling without heat.
Step End of Cycle Signal
Shortly before the cycle is complete, an audible signal will sound. If the Press Care option has
been selected, the audible signal will sound _ HI intermittently during the cool down portion of
Press Care. The signal can be turned off or vol- ume adjusted if desired.
Step Press Start
Push this button to start the dryer. The dryer START door must be shut for the dryer to operate, If the
door is opened during the cycle, the start button must be pushed again to resume the cycle once
the door is closed,
INTELLIDRYWRINKLEFREEFABRICS WITH PRESS CARE
automatically senses the moisture in the load and shuts off when the select-
ed dryness level is reached. It mini- mizes wrinkles of synthetic fabrics
such as acrylic, nylon, polyester or blends by providing a
dry is the initial preferred setting for the majority of loads.
INTELLIDRY REGULAR automati- cally senses the moisture in the load
and shuts off when the selected dry- ness level is reached. This cycle is
designed for loads such as towels, underwear,
control to the desired dryness level (more dry - less dry). The line between more dry and less dry is the initial preferred setting for the major- ity of loads.
TIME DRY/AIR FLUFF may be select- ed for any load if the lntelliDry sensor system is not used. Set the control to
the desired number of minutes and choose the appropriate drying tern-
perature of the load. A time dry of up to 60 minutes may also be selected. Place the control dial pointer at the desired number of minutes. Do not select the Dryel option button.
Note: The dial can be turned in either direction to select a cycle. Once started,
the dial will not advance at a specific rate during the IntelliDry cycles.At first the dial may not advance at all.
Towardthe end of the cycle (when the load begins to dry) the dial will advance
at a more regular rate and much more quickly. This is normal operation.
6