BEFORE YOU CALL
TOPIC | POSSIBLE CAUSE | SOLUTION | |
OPERATION |
|
| |
|
|
| |
Dryer Does Not Run | Electrical power cord may not be plugged in, or con- | Make sure plug from power cord fits tightly into wall outlet. | |
| nection may be loose. |
| |
|
|
| |
| Fuse blown, circuit breaker tripped, or power outage | Replace fuse or reset circuit breaker. Do NOT increase fuse capacity. Call qual- | |
| occurred. | ified electrician to correct circuit overload problem. Call local utility company to | |
|
| correct power outage. | |
|
|
| |
| Dryer door is not closed. | Push door closed. | |
|
|
| |
| Timer knob must be pushed in to restart dryer. | If dryer door was opened during a cycle, the timer knob | |
|
| must be pushed in to restart the cycle. | |
|
|
| |
Dryer Does Not Heat | Dryer set to AIR FLUFF setting. | Reset TEMPERATURE knob. | |
|
|
| |
| Damper on weather hood is stuck closed or frozen. | Severely restricted airflow will cause dryer to stop heating. | |
|
| Check weather hood and exhaust system for restrictions. | |
|
|
| |
| Gas supply is shut off (Gas dryers only). | Check other gas appliances in house for gas supply. | |
|
|
| |
| Exhaust system or outside vent is blocked. | Check exhaust system and vent area for obstructions. | |
|
|
| |
APPEARANCE |
|
| |
|
|
| |
Screen in Back of | Heat causes the metal to darken. | Normal. Will not affect performance. | |
Drum Darkens |
|
| |
Dryer Drum | Fabric dyes that are not set can stain the dryer drum. | Make a paste from powdered detergent and rub on stain. Though you may not | |
Becomes Stained |
| be able to remove stain immediately, the stain may fade and disappear over | |
|
| time. | |
DRYING |
|
| |
|
|
| |
Long Drying Times | Improper exhaust system. | Check Installation Instructions for length of proper exhaust system. Only use 4” | |
|
| diameter rigid or | |
|
| ing. Check weather hood and exhaust system for restrictions. | |
|
|
| |
| Overloading. | Dry one wash load at a time. | |
|
|
| |
| Sorting. | Separate heavy items from lightweight items. | |
|
|
| |
| Full lint filter. | Clean lint filter before each use. | |
| Clothes too wet from washer. | Check that the washer had enough spin speed to extract water. Clothes may | |
|
| need to be rearranged in the washer and put through an additional spin cycle to | |
|
| extract enough water before drying. | |
|
|
| |
Lint | Full lint filter. | Clean lint filter before each use. | |
|
| ||
Improper sorting. | Separate lint producers (cotton towels) from lint attracters (synthetic fabrics). | ||
| |||
|
|
| |
| Paper, tissues, or other items left in pockets. | Remove items from pockets before washing or drying. | |
|
|
| |
| Overloading | Overloading reduces airflow so lint is not collected in filter. Dry one wash load at | |
|
| a time. | |
|
|
| |
| Over drying | Adjust controls for shorter drying time. | |
|
|
| |
Static | No fabric softener was used. | Use a fabric softener. | |
| Synthetic fabrics can cause static. | Use a fabric softener. | |
|
|
|
10