Whirlpool 2DLSQ8000JQ3 manual Troubleshooting, Washer stops, Washer won’t drain or spin

Page 9

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid the cost of a service call...

Washer won’t fill, rinse or agitate

■Check the following:

Is the power cord plugged in?

Is the indicator on the Cycle Control knob properly lined up with a cycle? Turn the Cycle Control knob to the right slightly and pull to start.

Are the water inlet valve screens clogged?

Are both the hot and cold water faucets turned on? Is the water inlet hose kinked?

■Does the water level seem too low, or does the washer appear to not fill completely?

The top of the agitator is much higher than the highest water level. This creates a perception that the washer is not filling completely. This is normal.

■Is the lid open?

The lid must be closed during operation. Washer will not agitate or spin with the lid open.

Washer stops

■Check the following:

Is the power cord plugged in?

Is the indicator on the Cycle Control knob properly lined up with a cycle? Turn the Cycle Control knob to the right slightly and pull to start.

Are the water inlet valve screens clogged?

Are both the hot and cold water faucets turned on?

Washer won’t drain or spin

■Is the drain hose clogged, or the end of the drain hose more than 72 in. (183 cm) above the floor?

See the Installation Instructions for proper installation of drain hose.

■Is the lid open?

The lid must be closed during operation. Washer will not agitate or spin with the lid open.

■Is there excessive sudsing?

Always measure detergent. Follow manufacturer’s directions. If you have very soft water, you might need to use less detergent.

■Is your voltage low?

Check your electrical source or call an electrician. Do not use an extension cord.

Washer continues to fill or drain, or the cycle seems stuck

■Is the top of drain hose lower than the water level in washer?

The top of the hose must be higher than the water level in the washer for proper operation. See the Installation Instructions.

■Does the drain hose fit too tightly in the standpipe, or is it taped to the standpipe?

The drain hose should be loose yet fit securely. Do not seal the drain hose with tape. The hose needs an air gap. See the Installation Instructions.

Is the water inlet hose kinked?

■Is there power at the plug?

Check your electrical source or call an electrician.

■Has a fuse blown or is the circuit breaker open? If problem continues, call an electrician.

■Are you using an extension cord? Do not use an extension cord.

■Is the washer in a normal pause in the Casual/Permanent Press (or Hand Washables) cycle?

The washer pauses for about 2 minutes in the Casual/ Permanent Press cycle. Allow the cycle to continue.

The Hand Washables cycle (on some models) features periods of agitation and soak.

■Is the lid open?

The lid must be closed during operation. Washer will not agitate or spin with the lid open.

■Is the washer overloaded? Wash smaller loads.

Washer makes noise

■Is the load balanced and the washer level?

The wash load should be balanced and not overloaded.

The washer must be level. The front feet should be properly installed and the nuts tightened. Reset the rear leveling legs (if needed). See the Installation Instructions.

■Did you completely remove the yellow shipping strap with cotter pins?

See the Installation Instructions.

■Are the gears engaging after the drain and before spin, or is the upper part of agitator clicking during wash?

These are normal washer noises.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Lavadoras Automáticas DE Fácil USO EASY-TO-USE Automatic WashersUse & Care Guide Manual de uso ycuidadoÍndice Table of ContentsYour safety and the safety of others are very important Washer SafetyParts and Features Control panelControl panel Lid Model and serial number label Understanding Washer Cycles Washer USELoading Normal SoundsStarting Your Washer Normal cycle Selecting a Cycle, Time TemperatureCasual/Permanent Press cycle Delicate cycleWasher Care Washer stops TroubleshootingWasher won’t drain or spin Washer continues to fill or drain, or the cycle seems stuckWasher basket is crooked Washer leaksAgitator operation Dispensers clogged or bleach leakingIf you need replacement parts Wash/Rinse temperature not what I selectedFor warranty information Load is tangled or twistedSu seguridad y la seguridad de los demás es muy importante Seguridad DE LA LavadoraPanel de control Piezas Y CaracterísticasPara comprender los ciclos de lavado Funcionamiento DE LA LavadoraCómo cargar la lavadora Sonidos normalesPuesta en marcha de la lavadora AdvertenciaCómo seleccionar un ciclo Tiempo y temperatura Ciclo NormalPara detener o volver a poner en marcha su lavadora Enjuague y exprimido Cuidado DE LA LavadoraDesagüe y exprimido Limpieza de su lavadoraSolución DE Problemas La lavadora pierde agua La lavadora hace ruidosLa canasta de la lavadora está torcida Funcionamiento del agitadorAyuda O Servicio Técnico

2DLSQ8000JQ3 specifications

The Whirlpool 2DLSQ8000JQ3 is a standout model in the realm of washing machines, showcasing a blend of advanced technology and practical features designed to enhance user experience and ensure optimal laundry performance. This top-loading washer is crafted for efficiency and convenience, making it an ideal choice for households of various sizes.

One of the key features of the 2DLSQ8000JQ3 is its 3.8 cubic feet capacity. This spacious drum provides ample room for large loads, allowing users to wash more clothes in a single cycle and reducing the number of loads required during laundry day. The machine's design promotes effective washing while maintaining a compact size that easily fits in tight spaces.

The washer is equipped with a robust Agitator, which plays a crucial role in delivering thorough cleaning results. The agitator ensures that detergent is effectively distributed throughout the load, while also providing a gentle, yet effective, wash action that protects fabrics from wear and tear.

Another notable technology in the Whirlpool 2DLSQ8000JQ3 is its Variety of wash cycles. The washer features multiple settings tailored to different fabric types and soil levels, ensuring that every load receives the best care. From delicate fabrics to heavily soiled items, users can easily select the appropriate cycle for optimal cleaning results.

Furthermore, this model incorporates a Load Sensor, which automatically adjusts water levels based on the size of the load. This feature not only conserves water but also enhances energy efficiency, helping users save on utility bills. In addition, the machine's Energy Star certification is a testament to its energy-efficient design, promoting eco-friendly laundry practices.

The 2DLSQ8000JQ3 also includes a convenient end-of-cycle signal, providing an audible alert when a wash cycle is complete. This feature ensures users can promptly attend to their laundry, preventing clothes from sitting in the washer for extended periods and reducing wrinkles.

Overall, the Whirlpool 2DLSQ8000JQ3 combines innovative technologies with user-friendly features, making it an excellent choice for those seeking a reliable, efficient, and feature-rich washing machine. With its durable design, versatile wash cycles, and energy-saving attributes, this washer is positioned to meet the demands of modern households.
Top Page Image Contents