Whirlpool 6LA6300xY manual Whathappensin eachcycle, Gentle Wash System

Page 5

3.Select cycle and wash time Start the washer

lPush in the Cycle Control Knob and turn it clockwise.

lStop when the indicator on the knob’s outer ring points to the number in the wash cycle you want. The numbers are minutes of wash time.

l

l

Start the washer by pulling out the Cycle Control Knob. The washer will fill to the selected water level with the selected wash water temperature. The washer will begin agitating immediately after filling. Agitation can occur with the washer lid up or down.

To stop the washer at any time, push in the Cycle Control Knob. To restart the washer, pull out the Cycle Control Knob.

Whathappensin eachcycle

Each cycle has been designed for different kinds of fabrics.

When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts.

After agitation starts, the knob turns clockwise until it points to OFF and the cycle ends.

The washer will pause briefly throughout each cycle. These pauses are normal for washer operation.

Gentle Wash System

For better fabnc care in the REGULAR and PERMANENT PRESS Cycles, the agitation speed is reduced during the last few minutes of wash agitation time.

5

Image 5
Contents 6LA6300xY Use&CareGuideContents Additionalsafetyinstructionsandyourresponsibilities ImportantSafetyInstructionsPermanent press fabrics OperatingInstructionsStartingyourwasher Gentle Wash System Whathappensin eachcycleEach cycle has been designed for different kinds of fabrics Minutes Low Speed Permanent Press/Normal Cycle Operating Alndicates that machine is pausing for a brief soak periodKnits Gentle/Normal Cycle ThatPartial Drain No Agitation Rinseandspin OtherOperatingInstructionsDrainandspin Pull Cycle Control Knob out. The washer will drain and spinLiquidbleachdispenser Water can siphon out See Installation Instructions If YouNeedServiceOrAssistanceIf you need FSP Replacement parts+ Page Page Page Whirlpool*AutomaticWasherWarranty