Haier 650 user manual How to change the direction of the drain hoses

Before Using

How to change the direction of the drain hoses

Figure 1 indicates the ex factory installation
position of the drain hose.	Soft item

Extend the drain hose from the side of spin tub

Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the cabinet. Take the hose out of the fixing groove.

(See to Figure 2).

Embed the drain hose into the groove along the side Soft item of the spin tub in the order of (1)~(3), heading for the

side of the spin tub. (See to Figure 3).

Embed the drain hose into the groove with hands. Take care not to damage the drain hose in fastening the fixing clamp.

Extend to the spin tub side

Extend the drain hose from the rear side

Back

Front

Figure 1

Figure 2

Embed into the

groove in turn Figure 3

Take out the drain hose from the fixing groove. Extend it from the rear side as per the direction of the arrow. (When the drain hose is extended from the rear side, it can be hung on the point for drain hose at the two sides of the cabinet.) (See to Figure 4).

Figure 4

Install the water inlet hose; Select the water level

Insert the water inlet hose into the water-filling	Water inlet hose
entrance on the control panel, then push the		Water	inlet jointer
water-filling jointer into the entrance on the
control panel. (To dismantle the water inlet pipe,	Push	Water	inlet
just push the control handle as indicated in the	Control handle
figure and pull it out)

Select water level according to the quantity of the laundries.

Set the water level adjusting lever to needed line.

Page8

Water level indicator

High High

about 43L

Medium

Medium

about 36L

Low Low

about 30L