Installation and adjustment
Please install and adjust the machine according to the requirement of the mannual. It is very important to your security and correct operating the machine.
3 Push the " WATER LEVEL "button,select suitable water level
Install the lint filter
1.Press downward to assemble. 2.Pull upward to detach.
Install the bottom plate
After you open the package, please lean the washing machine gently down on soft items ( like the towel cloth,blanket, etc. ).
Install the bottom plate to the bottom of the machine with the eight screws by a cross screwdriver, then lift the machine up gently. See to the figure:
After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth. After defection, it can set the water level automatically. To select other water level, first push the "start/pause" button, then push the "water level" button to set the water level.
4 Push the "PROGRAM/RESERVE" button to select suitable reserve wash program
Back
Front
Soft items | Screw | Bottom plate |
|
| |
|
|
|
Adjust the Installation position
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing procedure to be finished at reserved time, please push the "PROGRAM/RESERVE" button to set the reserve wash program two seconds. Refer to "PROGRAM/RESERVE"
button in Page 11 for selection.
the washing will be finished after 18 hours.
5 Push the "Start/Pause" button
Confirm it's horizontal:
Hang the lead line to check if it is horizontal.
Adjust the adjustable leg:
1 .To twist the adjustable leg, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the leg.
Loosen
2 . After adjustment, fasten the nut.
High
the adjustable nut
Fasten
the adjustable leg
Low
6 Finish washing
After finishing wash it will switch off power automatically