Haier HWM6815 user manual How to change the direction of the drain hose, Usage of the drain hose

Lower bread Figure 4

4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.

5.If the extra hose is too long, cut it either at A or at B point.

Claws at the two sides

Screw

Top claw

4.To install the back cover, first hang the lower beard of the back cover on the cabinet, then push the claws at the two side and the upper end from bottom to top to resume the original setting. Be careful not to do

it by force. Then fasten

the screw (two points) (as indicated in Figure 4).

3.Extend the drain hose from the installation hole at the right side of the base frame. Fix the drain hose onto the base frame with the drain hose frame and fasten the screw. Then set the drain hose hook on the drain hose and hang the drain hose on the hanging hole of the cabinet. (As

indicated in Figure 3)

Figure 3

How to change the direction of the drain hose

1.Loosen the fastening screw of the back cover to take off the back cover. Be careful not to do it by force to prevent breaking the claw of the back cover.(as indicated in Figure 1)

Back cover

Figure 1

2.Take off the drain hose from the cabinet. Nip the drain hose outlet slightly. Dismantle the drain hose hook. Loosen the fixing screw of the drain hose frame to dismantle the drain hose frame. Pull the drain hose into the cabinet from the left side of the base frame.

Drain hose frame

Figure 2 Screw Nip the drain hose outlet

and take off the drain hose hook

Usage of the drain hose

The drain hose shall drain smoothly 1.The height of the drain hose shall be

less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way.

2.Do not trample or press the drain hose.

<10cm

If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.

5