MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
Monitoring
In this section you can configure how the cameras perform monitoring/recording and the related properties. 
Monitoring and choose the camera you want to configure.
1.Motion Detection
Sensitivity:
In this area, you can adjust the motion detection sensitivity from 0 to 100 (system default: 70). The higher the value is, the better the sensitivity the system can detect.
Record with Time Stamp:
You can also add time information on the recorded video by checking Record with time stamp and choose the color of the time display.
MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
Beep upon detected motion:
By checking Beep upon detected motion, you can enable the alarm to start beeping once motion detected. You can do an
instant test it by clicking 
and the following two signs represent different situations.
: Motion detected in the detecting area
: No motion detected in the detecting area
2.Recording
You can choose the suitable recording mode among these three:
Record when start monitoring:
The system starts recording once the monitoring starts.
Record when motion detected:
The system starts recording only when motion is detected, and continues recording for 1~120
is set in the Stop recording after |
| sec. section.) |
Don’t record:
The system doesn’t record no matter what happens.
3.Quality
This section allows you to choose the compressed program and adjust the image quality from 0 to 100 (default 50). The higher the value is, the lower the compression ratio gets, and the larger disk space is required. You can also decide the recorded file size by changing the compression ratio. If you select Fast Recording with MJEPG format (lower compression ratio), the system record faster, and therefore, the file size is bigger. On the contrary, if you select High Compression Ratio with MPEG4, the recorded file size will be smaller for they are highly compressed.
47 | 48 |
