MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
Alarms
Alarm to list the alarm already been configured.
You may right-click the mouse on 
Alarm to add a new alarm
up to 64 alarms. Click any desired alarm to enter the setup screen of that alarm.
1.Alarm ID
In the No. field, you can see the alarm number. Also, you can set up the alarm name in the Name field.
2.Conditions
To set the event condition for cameras, check Motion field of the desired cameras to make their detected motion as an event to trigger the alarm. And check Video Loss field of the desired cameras to make their weak signal or video loss as events to trigger the alarm.
MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
For sensors, select High (Closed/ON) or Low (Open/OFF) to be the event condition. Note that for the alarm to be triggered, both event conditions for the camera and the sensor have to be met.
3.Action
Recording & Relay Output:
To set actions, check the Recording column of the desired camera to start recording, and check the Enabled column of the desired relay to generate outputs when both the event conditions for cameras and sensors are met.
Relay and Full Screen on Motion retrieve
After an input is triggered, the output of relay and full screen on motion will revert to normal status after the time you set.
Sound, Call out and Email will be activated
The output ways you designate after an alarm is generated offer you to decide the deferment once an alarm is triggered.
Full Screen on Motion:
During surveillance, you can have the system to instantly pop up the image
Sound Alarm:
Check Sound to play a .WAV file when an alarm is triggered. You
can assign the path of a specific .WAV file for the system play, or
you can record a new .WAV file by clicking 
. To do so, follow the steps below:
A.Click 
and the recording utility pops up.
B.Click 
to start recording.
C.Click 
to stop recording.
D.Save it as the .wav file.
53 | 54 |
