LG Electronics NL-7000 AC If feature is active AND optional alarm box or SP-box is connected

LA GARD Locks BV

E-mail: info@lagard.nl Internet: http://www.lagard.nl

Kantooradres:	Postadres:
Vlijtstraat 40	Postbus 127
NL-7005 BN Doetinchem	NL-7000 AC
H.R. te Arnhem nr: 09087869	Tel: (+31) 314 376 876
BTW nr: NL 8038.72.987.B01	Fax: (+31) 314 376 878

Silent alarm:	If feature is active AND optional alarm box or SP-box is connected.
(must be programmed)	If the last digit is chosen one higher (+1) when entering the code, the lock
	will open as usual (double signal), but at the same time the alarm box is
	activated. Example: Combination: 471147			Alarm code: 471148
Time delay for opening:	If feature is active:
(Must be programmed)	After entering a valid code (double signal) the delay period starts, the LED
	flashes red each 2-second interval.
	At the end of the delay period the Open window starts, the LED flashes
	each second and the lock beeps every 2 seconds.
	To open the lock, a valid code has to be entered during the Open window.
	If the Open window expires without the lock being opened, then the lock is
	secured again with the Time delay.
	Delete current delay time: press key “0”
	Extend current delay times: enter valid code. The delay period will start
	again.
Time delay override:	The user ID# 9 (money carrier) can open immediately. At the operation
(Must be programmed)	with two codes the ID# 9 is entered as the second code.
Power supply:	When the batteries are running low, the lock will signal for about 3
	seconds while being opened. The batteries then have to be changed.
	Use DURACELL ALKALINE batteries only!
	The codes are stored in the lock also without power supply.
	3710, 3750 and 3750K: Battery compartment is in the bottom of the entry.
	3035: Open battery box (inside door) and insert new batteries.
	If the batteries have not been changed in time and the tension does not
	suffice to cancel the lock‘s blocking feature, a new 9V DURACELL
	ALKALINE battery can be pressed onto the contacts on the entry, until
	the code has been entered and the entry is rotated.
	When Time Delay is programmed, use a battery clip (on general sale).
	Black upper position, red lower position.
	When connected to the alarm equipment through the interlock device “SP“
	then the power supply is secured from this place.
Safety notice:	• Change the manager code immediately
	• Do not use personal data (birth date) as a code
	• Keep the code from unauthorised use
LED and acoustic signals:	1 x short signal	enter confirmation
	2 x short signal	valid code entered
	3 x short signal	wrong code, not accepted
	6 x short signal	remote disable, blocked by the alarm
		equipment
	LED signal each 10sec. 1 flashing		blocking time after a wrong tries
	LED signal each 2sec.		Time delay before opening is running
	Alternate LED and acoustic signals		Time window for opening is running

A series of triple signals, ca. 3seconds: Low battery

	Still possible ca. 10 openings.
	According to the battery capacity there may be also less signals
	therefore the battery change should be made also in case of
	double signals
	Use 9V DURACELL ALKALINE batteries only!
LG 39E Combogard EN	2
Revise: 1
Datum: 16-02-05