Intel MP3000, MP2016, MP5000 user manual Exit PTZ Controller

MicroJack User’s Manual

EYES Pro/MP2016/MP3000/MP5000

The PTZ camera will run AutoPan based on your preset position

settings. For example, if is chosen and the Dwell/Speed of preset position 1 and 2 are 3 seconds/30 per second and 6 seconds/90 per second.

Therefore, once you click the AutoPan button, the camera first turns at a speed of 30 /sec from its current position to position

1 and stays for 3 seconds, then from position 1 to 2 at a speed of 90 /sec and stays for 6 seconds. The camera continues to go

around in such a fashion (2Æ3, 3Æ4, 4Æ1, 1Æ2, …..)

PTZ cameras of different makes can have different ways to run the AutoPan function and might differ from the above. Refer to the respective user’s manual of the PTZ camera.

2.Exit PTZ Controller

Simply click to exit from PTZ controller interface.

MicroJack User’s Manual

EYES Pro/MP2016/MP3000/MP5000

Status Monitoring

Alarm / Relay /Sensor Status

On the right side of the main surveillance window is a panel that shows alarm, relay and sensor status. Installed sensors are shown in bright color while not installed ones remain dark. Once a sensor is activated, the color will turn yellow. For relays, installed ones are shown in bright color and activated ones turn yellow color.

When an alarm is triggered, the will turn

red color. Double-clicking on this button will bring up the following dialog box.

97 98