Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Install the lint filter
After opening the package,please take out the lint filter from the document bag,install it to the overflow filter of the wash tub.See to the figure.
Overflow filter
Lint filter
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage.
2.Do not tramp or press the drain hose.
<10cm
3.If the drain hose is too long, cut it at mid point. |
| ||
| To make smooth drainage, cut the front end of |
| |
| the hose slantingly. |
|
|
4.If extra drain hose is needed , please make | > 30mm | ||
|
|
| |
separate purchase. The inner diameter of | the |
| |
extra hose shall not less than 30mm, and | the | <1.5m | |
|
|
| |
length shall not exceed 1.5m. |
|
| |
If | the extra hose is too long, cut it either |
| |
at | point A or B. |
|
|
A B
Filling water from wash water-filling entrance
The appliance is to be connected to the water mains using new
Insert the water inlet hose into the
entrance, then push the
the entrance on the control panel. (To dismantle
the water inlet pipe, just push the control handle
as indicated in the figure and pull it out)
Water inlet hose
Water-filling jointer
Push
Control handle 
Wash
4