Safety precautions
Please plug the power plug on special | The washing machine must be positioned so that |
receptacle. Be sure to use | the plug is accessible. Be sure to pull the plug off |
power receptacle. Ensure that the earthing | and close the water faucet in following cases: |
prong of the power receptacle is earthed | power failure, delivering the machine, setting the |
Disposal after washing
After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.
reliably. Use leakage protector if possible. | machine idle or cleaning the machine. Do not plug |
| or pull the power plug with wet hand. |
Do not bend ,extend, twist, bind by force. Do not press or nip it with weight.
Keep the pin of the power plug clean, if the power plug is polluted with dust, please wipe with dry cloth carefully.
If the power cord or the power plug is bad, to avoid risk it is required to have it replaced by the technicians of our special shop or our customer care agent.
In case the washing machine is installed on ground with | Do not use water hotter than 50 . |
carpet, do not block the ventilation hole with carpet. |
|
T h e v e n t i l a t i o n holes at the bottom
Carpet
Do not put the machine at damp place like | Do not wash | |
the bathroom. Never wash it with water. Do | the raincoat, bike covers etc. to avoid | |
not put wet laundries on the control panel. | ||
abnormal vibrations in spinning. | ||
|
Clean the detergent box and set it on the control panel seat.
1.The method of dismantle: Push it up aslant and gently.
2.The method of install : install it upwards and aslant and push it in .
DismantleInstall
The filter screen of the water inlet valve is likely to be blocked by foreign materials and influence the water inlet.
Please clean it with brush every two months.
The lint filter must be used during washing.
It must be cleaned in time after each using. Lint filter:
1.Push down the spring piece of the top lint filter to make the claws out of the filter cover, and then pull out the lint filter to get it down. 
figure1
2.Pull the back of the lint filter, and then you can
get down it off the front cover of the lint filter. 
figure2
3.Sweep the rubbish in the lint filter.
4.Put the back of the lint filter into the front cover . 5.Put the lint filter into filter cover, and make it tight .
6.Make sure the lint filter well installed, or it can influence your use.
The back cover of lint filter | Up | |
Up |
|
|
Dismantle | Dismantle |
|
Install |
| Install |
|
| |
| Down |
|
Down | The front cover of lint filter | |
|
| |
Figure 1 | Figure 2 | |
If the cabinet is dirty, wipe it with wet cloth
Do not flush it directly with water.
Wipe it with neutral detergent.
Do not wipe it with thinner, petrol, alcohol etc.
Do not let the machine share one receptacle with other electric appliances. If the plugging into the receptacle is loose, do not use the plug any more.
Petrol | Thinn | er |
Alcohol |
|
|
1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).
2.Do not store water in the washing machine for a long period. Drain the water completely after each using. 3.Be sure to pull off the power plug before maintenance.
4.Hang up the power cord and drain hose.
5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time (about 1 hour), then close the top lid.
2