XS Scuba Buoyancy Compensator manual Post Dive Care & Maintenance

Page 20

.20 BC Owner’s Manual

Post Dive Care & Maintenance

With proper care, your XS Scuba BC will provide many years of reliable service. The following preventative maintenance must be performed to extend the life of your BC:

Avoid prolonged exposure to direct sunlight and extreme heat. Nylon fabric can quickly fade when exposed to the sun’s ultraviolet rays, and extreme heat may damage the welded seams of the BC’s air cell.

Avoid repeated or prolonged use in heavily chlorinated water, which can cause the BC fabric to discolor and decay prematurely.

Do not allow the BC to chafe against any sharp objects or rough surfaces that could abrade or puncture the air cell. Do not set or drop heavy objects such as block weights on the BC.

Avoid any contact with oil, gasoline, aerosols, or chemical solvents.

To preserve the life of the air cell, thoroughly rinse it inside and out with fresh water after every day of use, following these steps:

1.Pressurize the power inflator with low pressure air via the LP hose.

2.Using a garden hose, direct water through the oral inflator to flush the interior of the air cell, and then thoroughly rinse the exterior of the BC. Before rinsing, ensure that the power inflator is pressurized with air. This will prevent debris and contaminants from entering the inflator valve if the inflator button is accidentally depressed.

3.Completely drain the air cell of water through the lower OPV/dump valve by pulling the ball/cord assembly.

4.Fully inflate the BC, and allow it to dry inside and out. Then store it partially inflated, away from direct sunlight, and in a clean, dry area. Do not store the BC in an enclosed space, such as a car trunk, where it may be exposed to temperatures below 0º F (-18º C) or above 120º F (49º C).

5.To avoid stress on the air cell or harness assembly, remove all weight from the trim weight and X-Lock™ releasable compartments before storing the BC. Soft weights especially, can discolor the BC over time.

CAUTION: DO NOT attempt to perform any disassembly or service of your XS Scuba BC. Service requiring disassembly must only be performed by a factory trained XS Scuba technician. To obtain any service or repair, it is important to bring your BC to an Authorized XS Scuba Dealer.

Optional Accessories & Special Features

You can purchase the following accessories for your new BC from your Authorized XS Scuba Dealer:

XS Scuba, Inc

Image 20
Contents Compensator Definitions of Warnings, Cautions and Notes Table of Contents General Precautions and Warnings DESCENT, do not Hesitate to Remove and Ditch WeightIntroduction Intended Use & Function of Your BC Valves Cummerbund Waistband Primary Adjustment PointsShoulder Straps Integrated Weight Systems Cylinder Band with BuckleTank Locator Strap Sternum StrapReleasable Trim Weights Lock Integrated Weight SystemCylinder Mounting Threading the Cylinder Band & Buckle Preparation & SetupLP Inflator Hose Installation Attaching the BC to the Cylinder Lock Integrated Weight System Filling the Weight Pockets Integrated Weight SystemReleasable Trim Weights Lock Integrated Weight System Pocket Installation Donning the BC Inspection Checklist Pre-Dive InspectionRules For Personal Weighting Diving With Your XS Scuba BCDiving With an X-Lock Integrated Weight System Oral InflationVenting With the Oral Inflator Power InflationVenting & Dumping Air Right Shoulder OPV / Dump Valve not featured on all models Venting With the REVPost Dive Care & Maintenance Optional Accessories & Special FeaturesDealer Inspection & Service AirWave Inline Octopus part no. RG325Limited Two-Year Warranty What Is CoveredWhat Is Not Covered What You Need To DoService Record Returning Your BC For Service