Humminbird ID 600 manual

Page 28

press the ON-OFF button while within the Fish ID menu. Pressing the ON-OFF button again reactivates the ID function.

Image 28

Contents Page Installation Overview AccessoriesParts Supplied Determining How to Mount the Transducer Alternate Transducers and Mounting Methods Portable MountingTrolling Motor Mounting Thru-Hull MountingBeginning Installation Transducer ExchangeTransom Installation Step One Determine Where to Mount the TransducerStep Two Drill the Mounting Holes Step Three Assemble the TransducerStep Four Mount the Transducer to the Transom Step Five Adjust the Running Position of the TransducerConfirm the pivot angle has not changed Page Step Six Route the Cable Step One Determine the Mounting Location Inside the Hull InstallationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Step One Determine Where to Mount Control Head InstallationStep Two Connect the Power Cable to the Boat Page Step Three Drill the Mounting Holes Step Four Run the CablesPage Step Five Assembling the Connector Holder Your Humminbird is now ready for operationTest the Installation Installing the SeaScope ID600 Gimbal Mount InstallationTesting the Installation Using the Built-In Simulator Using the SeaScope ID600Operating the SeaScope ID600 Factory setting +0/FEET SensitivityBottom Alarm Fish AlarmZoom Bottom LockDisplay Speed Depth Range Fish ID