Humminbird ID 600 manual

Page 15

fuse in the connection. If you must wire the control head directly to a battery, be sure to install an inline fuse holder

Image 15

Contents Page Accessories Installation OverviewParts Supplied Determining How to Mount the Transducer Thru-Hull Mounting Alternate Transducers and Mounting MethodsPortable Mounting Trolling Motor MountingTransducer Exchange Beginning InstallationStep One Determine Where to Mount the Transducer Transom InstallationStep Three Assemble the Transducer Step Two Drill the Mounting HolesStep Five Adjust the Running Position of the Transducer Step Four Mount the Transducer to the TransomConfirm the pivot angle has not changed Page Step Six Route the Cable Inside the Hull Installation Step One Determine the Mounting LocationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Control Head Installation Step One Determine Where to MountStep Two Connect the Power Cable to the Boat Page Step Four Run the Cables Step Three Drill the Mounting HolesPage Your Humminbird is now ready for operation Step Five Assembling the Connector HolderTest the Installation Gimbal Mount Installation Installing the SeaScope ID600Testing the Installation Using the SeaScope ID600 Using the Built-In SimulatorOperating the SeaScope ID600 Sensitivity Factory setting +0/FEETFish Alarm Bottom AlarmBottom Lock ZoomDisplay Speed Fish ID Depth Range