Humminbird Wide 3D Vision manual Step Five Assembling the Connector Holder

Page 18

INSTALLATION

CONTROL HEAD INSTALLATION

Step Five - Assembling the Connector Holder

1.Insert the cable connectors into the connector holder. The cable connectors are labeled, and there are corresponding labels on the connector holder (Figure 26). The slots for the connectors are keyed to prevent reverse installation, so do not force the connector into the holder.

2.Carefully pull the excess cable from beneath the - mounting surface so the connector holder aligns with the mounting holes on the front of the mounting bracket (Figure 27).

3.Snap the support plate to the rear of the connector holder (Figure 28).

4.Insert the connector holder into place and use the two #6-32 x ¾” (9mm) screws to fasten it to the mounting bracket (Figure 28).

5.Install the control head by sliding it onto the mounting bracket until it is fully seated. To remove the unit simply depress the latch on the rear of the unit and lift (Figure 29).

Your Humminbird is now ready for operation.

Image 18
Contents Page Accessories Installation OverviewParts Supplied Determining How to Mount the Transducer Trolling Motor Mounting Alternate Transducers and Mounting MethodsPortable Mounting Thru-Hull MountingBeginning Installation Transducer ExchangeTransom Installation Step One Determine Where to Mount the TransducerStep Two Drill the Mounting Holes Step Three Assemble the TransducerStep Five Adjust the Running Position of the Transducer Step Four Mount the Transducer to the TransomConfirm the pivot angle has not changed Page Step Six Route the Cable Inside the Hull Installation Step One Determine the Mounting LocationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Control Head Installation Step One Determine Where to MountStep Two Connect the Power Cable to the Boat Page Step Three Drill the Mounting Holes Step Four Run the CablesPage Step Five Assembling the Connector Holder Your Humminbird is now ready for operationTest the Installation What YOU see on Screen Using the 3D View Page Using the 2D View Using the Combo View Control FunctionsMenu Functions SensitivityRange Zoom Page Bottom Alarm Page Page Triplog System OptionsPage Diagnostic Advanced OperationWide Side Operation Page