Humminbird Wide 3D manual

Page 37

Your Wide 3D View is now configured for Wide Side operation.

When you exit the "System Options" menu, the view you will see on-screen is shown above. Viewing both left and right sides simultaneously gives you an excellent tool when searching for bait fish or following a creek bed, however greater display resolution can be achieved by viewing only one side.

Experiment with the Wide Side transducer while operating it in a familiar area and learn how to make maximum use of the information displayed. Remember, if you are using a trolling motor mount, the information displayed is controlled by the direction the trolling motor is pointing, not necessarily the direction the boat is travelling.

Image 37

Contents Page Installation Overview AccessoriesParts Supplied Determining How to Mount the Transducer Portable Mounting Alternate Transducers and Mounting MethodsTrolling Motor Mounting Thru-Hull MountingTransducer Exchange Beginning InstallationStep One Determine Where to Mount the Transducer Transom InstallationStep Three Assemble the Transducer Step Two Drill the Mounting HolesStep Four Mount the Transducer to the Transom Step Five Adjust the Running Position of the TransducerConfirm the pivot angle has not changed Page Step Six Route the Cable Step One Determine the Mounting Location Inside the Hull InstallationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Step One Determine Where to Mount Control Head InstallationStep Two Connect the Power Cable to the Boat Page Step Four Run the Cables Step Three Drill the Mounting HolesPage Your Humminbird is now ready for operation Step Five Assembling the Connector HolderTest the Installation What YOU see on Screen Using the 3D View Page Using the 2D View Control Functions Using the Combo ViewSensitivity Menu FunctionsRange Zoom Page Bottom Alarm Page Page System Options TriplogPage Advanced Operation DiagnosticWide Side Operation Page