Humminbird Wide 3D manual

Page 12

The transducer cannot transmit through air. The water purges any air from between the transducer and the hull and fills any voids in the coarse fiberglass surface.

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Page Accessories Installation OverviewParts Supplied Determining How to Mount the Transducer Alternate Transducers and Mounting Methods Portable MountingTrolling Motor Mounting Thru-Hull MountingBeginning Installation Transducer ExchangeTransom Installation Step One Determine Where to Mount the TransducerStep Two Drill the Mounting Holes Step Three Assemble the TransducerStep Five Adjust the Running Position of the Transducer Step Four Mount the Transducer to the TransomConfirm the pivot angle has not changed Page Step Six Route the Cable Inside the Hull Installation Step One Determine the Mounting LocationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Control Head Installation Step One Determine Where to MountStep Two Connect the Power Cable to the Boat Page Step Three Drill the Mounting Holes Step Four Run the CablesPage Step Five Assembling the Connector Holder Your Humminbird is now ready for operationTest the Installation What YOU see on Screen Using the 3D View Page Using the 2D View Using the Combo View Control FunctionsMenu Functions SensitivityRange Zoom Page Bottom Alarm Page Page Triplog System OptionsPage Diagnostic Advanced OperationWide Side Operation Page
Top Page Image Contents