Chart Speed, Sonar View, Light, Contrast | Humminbird 1000 instruction

USING THE LEGEND 1000 SERIES

CHART SPEED / SONAR VIEW / LIGHT / CONTRAST / RTS WINDOW

screen. If the depth is deeper or shallower than the ranges on the display, the bottom contour will not be visible.

The manual range settings made to the LEGEND 1000 SERIES default to factory settings after the unit is turned off.

Chart Speed

CHART SPEED selects the speed at which the bottom information moves across the display. Options available

range from 1 (very slow) to 8 (very fast). Selecting a faster rate shows more information in the CHART WINDOW, but it moves across the display very quickly. Selecting a slower rate keeps the information on the display longer, but the chart information becomes compressed and may be more difficult to interpret. Setting CHART SPEED in relation to boat speed is often preferred.

The CHART SPEED setting is retained in memory after the LEGEND 1000 SERIES is turned off. The factory setting is 6.

Sonar View

SONAR VIEW (Deep Models only) selects the source of the sonar information being displayed. 200kHz displays

sonar information and FISH ID from the 200kHz beam only. 50kHz displays sonar information and FISH ID from the 50kHz beam only. SPLIT SCREEN presents the sonar information from the 200kHz

and 50kHz beams simultaneously in side-by- side windows. 200KHZ/50KHZ displays the sonar information from the 200kHz beam and target information from the 50kHz beam.

	The SONAR VIEW setting is	Split window 50kHz/200kHz,
	retained in memory after the	Split window 50kHz/200kHz,
	unit is turned off. The	shown with metric depth, °C
	unit is turned off. The	and kph digital readouts
	factory setting is 200KHZ.	and kph digital readouts
	factory setting is 200KHZ.	available on international
		models.

Light

LIGHT activates the display backlight and selects the brightness level. The

backlight is manually-controlled except when the unit first powers up. During initial power up, the backlight turns on at full brightness so the display will be visible at night. The backlight will then begin to decrease in intensity automatically until it is off in order to save energy. Selecting the CONTROL PANEL LIGHT choice stops the automatic off process, keeping the backlight on at the intensity level selected.

The Light setting defaults to factory settings after the Legend 1000 Series is turned off. The factory setting is ON full at power up and automatic decrease to OFF.

Contrast

CONTRAST enhances the viewability of the LCD by making it darker or lighter. Selecting a higher number

darkens the display; selecting a lower number lightens the display. The LEGEND 1000 SERIES uses sophisticated electronics to adjust the contrast level automatically; however, at times of extreme heat or cold, manually adjusting the contrast for best display may be needed.

The CONTRAST setting is retained in memory after the unit is turned off as long as it is set between 6 and 10. The factory setting is 8.

RTS Window

RTS WINDOW selects the width of the window dedicated to REAL TIME SONAR™. Selecting NARROW

decreases the width of the RTS WINDOW leaving more space for the CHART WINDOW, but some sonar returns will not be visible. Selecting WIDE makes the RTS WINDOW wider and shows more of the sonar intensity information, but less space on the LCD is available for sonar history. Selecting OFF turns off the RTS WINDOW and the entire LCD shows sonar history.

Note: When the RTS Window is adjusted to Wide, no grayscale information is shown.

The RTS WINDOW setting is retained in memory after the LEGEND 1000 SERIES is turned off. The factory setting is

NARROW.