Curtis 2200R, 2100R manual Troubleshooting, Problem Possible Cause

Page 15

5. TROUBLESHOOTING

The following checklist should help you to trou-		!
bleshoot any problems with the instrument. Turning		!
the instrument off and then on again after about 10
seconds may solve the problem in the simplest cases.
Make sure to observe the safety instructions in Section 1.
Problem	Possible Cause
No display	Voltage on Battery + terminal insufficient
Display is not
accurate	Check sender installation. Teflon tape, some
	lubricants and anti-sieze compounds may
	prevent proper grounding of single wire
	senders. Check sender-to-gage wiring for
	excessive resistance.

14

Image 15

Contents Read Instructions Carefully Model 2100RSafety Instructions Table of Contents 2111RXX-YYYY ZZ Model EncodementPage Accuracy Technical SpecificationsElectrical Operating Voltage Operating VoltagesVariable Parameters Operating CurrentIndicates standard setting Mechanical Output signal formatEnvironmental Temperature Salt spray fog VibrationHumidity Water/dust immunityTerminal Assignment For Models 2111R, 2112R, 2113R InstallationTerminal Assignments for Models 2211R, 2212R, 2213R Terminal Assignment for Model 2114RTerminal Assignments for Model 2214R Problem Possible Cause TroubleshootingMaintenance All specifications are subject to change Without notice Curtis INSTRUMENTS, INC