3M 3MTM quick start Communicating, Viewing your data

Page 11

Working with 3MTM Detection Management Software DMS

Communicating

1.When the EVM is On, plug the USB cable into the EVM and plug the opposite end to the USB port of your computer. (Refer to illustration below.)

Viewing your data

In DMS once your files are downloaded via Download button, view the data in the panel layout view or reports by clicking on appropriate buttons. See an example of the panel layout page below.

Image 11
Contents Quick Start Guide Start Screen and Measurement Views EVM and User InterfaceTurning On/Off and Navigating Particulate Measurements Reset/Clear memory, if necessary Start\File System menuOverview of running measurements Logging Particulates Particulate Zero CalibrationParticulate Advanced Calibration Gravimetric Logging VOCs Volatile Organic Compounds VOCsPID Zero Calibration PID Span CalibrationType of Gas Range Res Zero cal Span cal Toxic GasesCarbon Dioxide Gas Toxic and Carbon Dioxide Zero CalibrationLogging Toxic Gases or Carbon Dioxide Measuring particulatesToxic and Carbon Dioxide Span Calibration Particulate Air Flow Temperature and Relative HumidityLogging/Viewing Temperature and/or Relative Humidity Navigate to the Setup\Calibration\Flow RT rate screenNavigate to Start \Past Session screen Air VelocityViewing Logged sessions past sessions Impactor Care and Particulates Maintenance/CleaningThin-layer of silicone is applied to a clean impactor Sensors LocationsViewing your data Communicating074-301, Rev.D /13