WARNING: Power for enclosure models utilizing heater/blowers cannot be tapped off the secondary of the Coaxitron® receiver transformer or off of cam- era AC power (see Figure 2, Pins 9 and 14). Instead, for example, enclosure power for these purposes could be run off the pri- mary of the Coaxitron® transformer and routed to the enclosure via unused Pins 15 and 16 of the 37- Pin connector.
WARNING: There is no on/off switch. The CX9000 is “hot” when the fuse is installed and the input wir- ing is connected.
3.3 CONNECTOR ASSEMBLY
Assemble the connector parts according to the instructions below. Detail B, in Fig- ure 1, reflects the pin arrangement specific to the CX9000 Series receiver/drivers. Refer to Figures 1 and 2 during assembly. For best results, use an AMP style crimper when making the wire to pin connection.
The instructions that follow apply to all AMP style connectors regardless of pin size or pin number.
1.Slide the connector clamp assembly over the conductor cable. If the diameter of the conductor cable is such that the rubber boot will slide over it easily then slide the rubber boot onto the conductor cable at this time. If not, discard the rubber boot.
2.Prepare the wires from the conductor cable as follows:
a.Strip at least
b.Strip
c.Using an AMP style crimper, crimp the wires and their insulation to the connector pins. Refer to Detail A in Figure 1.
3.Slide the connector pins into the appropriate holes in the connector body until they snap into place. Refer to Figures 1 and 2 for correct pin arrangement, depending on model and options.
If your camera uses 12 VDC camera power, see Section 3.3.1, RECEIVER CONTROL OUTPUT FOR 12 VDC CAMERA OPTION.
If your receiver/driver has preset positioning, wire the presets. See Section 3.4,
COAXITRON® RECEIVER PRESETS.
If you will use auxiliary functions to drive small relays, lamps, or other external devices, see Section 3.5, AUXILIARY FUNCTIONS.
4.Push the connector clamp assembly (with boot, if used) toward the connector body. Screw the clamp assembly onto the connector body, being careful not to disturb the wires.
5.To complete the assembly, attach the appropriate clamp with the screws pro- vided and tighten.
6.When you are finished wiring the connector, connect the
Proceed to Section 3.6, POWER
Pelco Manual | 11 |