Pelco C554M-A (5/98) operation manual Specifications, Mechanical

7.0 SPECIFICATIONS

MECHANICAL
Latching
Fiberglass Box:	Two latches (accommodates padlocks - not supplied)
Anodized
Metal Box:	No latches. Two Phillips head screws open cover of box.
Painted
Metal Box:	Two latches (accommodates padlocks - not supplied)
ELECTRICAL
Input Voltage
Fiberglass Box:	120 VAC, 60 Hz (jumper selectable for 230 VAC, 50 Hz)
Anodized
Metal Box:	120 VAC, 60 Hz (jumper selectable for 230 VAC, 50 Hz)
Painted
Metal Box:	230 VAC, 50 Hz (CE version models)
Fuse Protection:	See Figure 7, AC Input and Fuse Values
Power
Consumption
Receiver:	5 vA (120 VAC or 24 VAC)
Pan/Tilt Supply:	140 vA maximum (120 VAC)
	50 vA maximum (24 VAC)
Lens Supply:	0-4 vA maximum
Camera Supply:	15 vA (typical)
Control Method:	15-pulse train (pulse width modulated) superimposed on the
	video signal during the vertical blanking interval by the control
	transmitter. Pulse train occupies one TV line period.
Pulse Amplitude:	Approximately 1 Vp-p added to video signal, 333 kHz nominal
Connectors:	Two BNC connectors for video input and output
	One 37-pin AMP CPC for control output (mate supplied)
	One adjustable PG-13 liquid tight gland connector for power
Input Video Level:	1 Vp-p nominal; 2 Vp-p maximum at less than 75 percent APL;
	1.5 Vp-p maximum at 90 percent APL

System Bandwidth: Less than 2 dB down at 10 MHz (exclusive of cable)

Power Cord:	3-wire grounded, #18 AWG
GENERAL
Construction
and Finish:	Dark gray fiberglass box (Most outdoor models)
	Anodized Aluminum box (Most indoor models)
	Gray polyester powder coat Aluminum box (230 VAC CE
	version models only)
Operating	-4°to 140°F (-20°to 60°C)
Temperature:

24 Pelco Manual C554M-A (5/98)