Oregon Scientific BAR610B user manual Manually SET Clock, Alarm, Strong Signal Weak / no Signal

NOTE Reception takes 2-10 minutes. If the signal is weak, it can take up to 24 hours to get a valid signal.

Clock signal reception indicator:

STRONG SIGNAL WEAK / NO SIGNAL

NOTE Clock reception is dependent on the successful

transmission of data from remote sensor. If is displayed, press RESET on sensor and press UP and DOWN together on the main unit and ensure sensor

has been successfully logged.

MANUALLY SET CLOCK

To set the clock manually, disable the clock signal reception first.

1.Press and hold CLOCK SET.

2.Press UP / DOWN to change the settings.

3.Press CLOCK SET to confirm.

The settings order is: time zone, 12/24 hr format, hour, minute.

BAR610P / BAR610PU: Time zone offset sets the clock +/- 23 hours from the received clock signal time.

NOTE If you enter + 1 in the time offset setting, this will give you your local time plus one hour. If you are in the

BAR610P_M_EN_R3.indd 5

US (BAR610PA only) set the clock to:		EN
0 for Pacific time	+1 for Mountain time
+2 for Central time	+3 for Eastern time

ALARM

To set the alarm:

1.Slide ALARM ON-OFFswitch to ON.

2.Press and hold ALARM SET.

3.Press UP / DOWN to change the settings.

4.Press ALARM SET to confirm. indicates alarm is on.

To activate / deactivate alarm:

•Slide ALARM ON-OFFswitch to ON / OFF.

To silence the alarm:

•Press SNOOZE to silence it for 8 minutes

OR

•Press any key to turn the alarm off and activate it again after 24 hours.

5

12/9/08 17:55:47