Start Your Installation
Connecting the Display (Figure 3)
To setup this display, please refer to the following figure and procedures.
1.Be sure all equipment is turned off.
2.Connect the DC power cord to the power connector; plug one end of the AC power cord into the power adapter, and the other end into an electrical outlet ().
3.Connect the VGA signal cable from display VGA input connector to the 15- pin connector of your host computer and tighten the screws ().
4.For LB1503R connect the DVI signal cable from display DVI input connector to DVI connector of your host computer and tighten the screws ()
5.For LB1503R connect the composite video cable from display video input to video output source ().
6.For LB1500RTC do not connect the USB cable until touchscreen software driver is installed! ()
7.Turn on your computer, display and or video source.
Figure 3. The LB1500R Connections | Figure 3. The LB1500RTC Connections | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note: Audio connector has been removed in later production units.
LB1500R / LB1500RTC / LB1503R User’s Guide | 7 |