Pelco C2943M manual Replacing the Camera, Camera Removal, DIP Switch Settings

Page 20

REPLACING THE CAMERA

NOTE: You must wear lead-free gloves and use ESD (electrostatic discharge) equipment when handling cameras.

CAMERA REMOVAL

1.Place the monitor face down, being careful not to scratch or touch the screen.

2.Use the thumb screw on the bottom of the monitor to open the access door. Refer to Figure 12.

Figure 12. Access Door

3.Unscrew the three metric screws (14 mm) that secure the camera. Remove the screws and spacers.

4.Gently pull the camera out of the monitor, being careful not to damage the attached connection leads. Detach the two camera connection leads from the camera.

DIP SWITCH SETTINGS

1. Locate the DIP switch. 2. the switches for your installation using a small screwdriver, refer to Figure 13.

Figure 13. DIP Switches

20	C2943M (1/08)

Image 20

Contents Public View Monitor Page Contents List of Illustrations List of TablesImportant Safety Instructions Regulatory Notices Radio and Television InterferencePackage Contents DescriptionModels SpeakersMounting InstallationWiring Rear Panel Connectors Operation Front and Side Panel ControlsInstalling Remote Control Batteries Remote Control Functions OSD Function Input Source DisplayPicture Screen Main MenuMenu Display Brightness Contrast Sharpness Color Tint Color TempMenu Field Definitions PictureCycle Setup Media Control Media Menu Display Camera Removal DIP Switch SettingsReplacing the Camera SW1-1 Video Format Camera Installation and Camera Adjustment Specifications ModelsElectrical Lens Specifications C2943M 1/08 Product Warranty and Return Information ISO9001