Topcon A3280 installation manual Weather Station Operation/Installation Manual

Weather Station Operation/Installation Manual

11.Ensure that the Pole Mount is orientated with the direction arrow sticker (on top of the Weather Station) pointing in the vehicle’s direction of travel

NOTICE

Aligning the mounting screw (nearest humidity sensor) is important, as it will ensure that the correct wind direction is displayed on the X20 console.

The direction arrow sticker is an indication only.

12.Screw the Back Nut (Figure 5-3 on page 5-3) up tight to lock in the position of the Weather Station sensor

13.Route the A3372 harness (Figure 5-2 on page 5-2), along the roof of the cabin and enter the inside of the cabin through vehicle approved Gromets

14.Fix the harness to the roof using the 5 self adhesive back clips (Y957) provided

15.Route the harness inside the cabin to where the X20 console is installed

16.Connect the 9 pin connector of the A3372 harness to the CAN Bus Port (Figure 2-4 on page 2-9 of the X20 console manual) at the back of the X20 console

17.Connect the 2 Pin Weatherpack connector on the A3372 harness to the X20 console’s Switched Power connector on the X20’s Power harness

6-4 www.topconpa.com