Transmission Information
The remote sensor sends temperature and weather condition information to the base unit.
After installing batteries into both units, allow 6 hours to analyze weather conditions and report forecasts.
Weather readings will update as follows:
•Current temperature updates approximately every 1 minute.
•Temperature and weather forecasts update every 6 hours during the first 24 hours of operation after battery installation.
•After 24 hours, updates occur every 1 hour.
If there are no changes on the display after 6 hours, press the “SYNC” button to send a new signal to repeat the transmission cycle.
After an extreme temperature change (ex. relocating the sensor from a warm indoor location to snowy outdoors), allow a few minutes for the temperature reading to stabilize.
Transmission Collision
Signals from other household devices, such as doorbells, home security systems and entry controls, may interfere. This is normal and does not affect the general performance of this product. The transmission will resume once the interference recedes.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
10