Finisar FWDM-1629-XX manual XI. Ordering Information Part Number Description, XII. References

Page 10

FWDM-1629-XX DWDM SFP Preliminary Product Specification – February 2005

F i n i s a r

XI. Ordering Information

 

Part Number

Description

FWDM-1629-XX

DWDM SFP with APD Receiver

 

XX = channel number (see product selection on page 2)

XII. References

1.Small Form Factor Pluggable (SFP) Transceiver Multi-Source Agreement (MSA), September 2000. Documentation is currently available from Finisar upon request.

2.“Application Note AN-2030: Digital Diagnostic Monitoring Interface for Optical Transceivers”, Finisar Corporation, April 2002.

3.“AT24C01A/02/04/08/16 2-Wire Serial CMOS E2PROM”, Atmel Corporation. www.Atmel.com

4.“Digital Diagnostic Monitoring Interface For Optical Transceivers Rev 6.1”, September, 2004. Documentation is currently available from Finisar upon request.

For More Information:

Finisar Corporation

1308 Moffett Park Drive

Sunnyvale, CA 94089-1133

Tel. (408) 548-1000

Fax (408) 541-6138 sales@finisar.com www.finisar.com

© Finisar Corporation

PRELIMINARY and Confidential

Page 10

Rev C, February 2005

 

 

Page 9 Page 10
Image 10
Page 9 Page 10
Contents N i s a r Product Selection Product Code Frequency THz Center Wavelength nmPin Descriptions Pin Symbol Name/DescriptionCircuit ground is internally isolated from chassis ground Parameter Symbol Min Typ Max Unit Diagram of Host Board Connector Block Pin Numbers and NamesII. Absolute Maximum Ratings Low Speed Signals Parameter Symbol Min Typ Max UnitsOptical Parameters Parameter Symbol Min Max Units VII. General SpecificationsVIII. Environmental Specifications VI. Wavelength StabilizationIX. Serial Communication Protocol E2PROM Description TBD pending MSAMechanical Specifications Dwdm SFP Outline DrawingXII. References XI. Ordering Information Part Number DescriptionFor More Information
Top Page Image Contents