INSTALLATION
Notes:
yChoose the mounting location where the unit will not interfere with the normal driving function of the driver.
yBefore finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.
yUse only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
yConsult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
yInstall the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
yIf installation angel exceeds 30° from horizontal, the unit might not give its optimum performance.
30
yAvoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.
TAKEOUTSCREWBEFOREINSTALLATION Before install the unit, please remove the two screws.
Take out screw before installation.
NOTE: If this unit is installed on the ship, you can use two pieces of plastic film to
seal the two holes after remove the screws. And this will be waterproof.
Installation Opening
You can select the installation area and the size of the opening according to the installation paper.
Installing the unit
1.Press the OPEN button, then the front panel will be folded down.
2.First remove the two caps on two sides of the unit. (Note to pull out the top side of the cap first.)
Then set the rubber base on the main unit close to the back of the front panel. Install the main unit to the dashboard thought the six screws with washers and the three brackets. You can use the plastic film to seal the six holes after remove the screws on the front panel of the unit.
3