Eagle Electronics EVR-100 manual Basic Operation and Key Functions

Page 12

Basic Operation and Key Functions

Key

Function

VOL/PWR

Volume and Power. Turn clockwise to power on. Continue to turn until a

 

comfortable volume is reached. VOL/PWR will also adjust the settings of an external

 

speaker, if connected

SQL

Squelch or Threshold Level. Sets the threshold level for the minimum receiver

 

signal. Turn fully counterclockwise until random noise is heard, then turn slowly

 

clockwise until the random noise disappears. Make another 1/4 turn clockwise for

 

best reception in open sea conditions.

16/9

Priority Channel. Also on the microphone. Press to cancel all other modes and to

 

tune into the priority channel. Press again to return to your original channel.

 

The default is Channel 16. To make Channel 09 the priority channel, hold down 16/9

 

until a beep sounds and 09 is displayed.

WX

Weather Channel. In USA and Canadian waters, press to hear the most recently

 

selected weather station. The WX symbol is displayed on the LCD.

 

Press + CH - to change to a different weather channel. Press WX again to return to

 

the most recent channel.

 

If the weather alert mode (ALT) is ON and an alert tone of 1050Hz is broadcast from

 

the weather station, it is picked up automatically and the alarm sounds. Press any key

 

to hear the weather alert voice message.

UIC

Channel Bank. Press to toggle between USA, International or Canadian channel

 

banks. The selected channel bank is displayed on the LCD along with the last used

 

channel. All the channel charts are shown in Appendix.

3CH +/-

Three Favourite Channels. Also on the microphone. Press to toggle between your

 

favourite channels. The C1, C2, or C3 symbol appears on the LCD to show which

 

favourite channel is selected.

12

EAGLE EVR-100Operation Instructions

Image 12
Contents EVR-100 Important Safety Information Please read carefully before installation and useTable of Contents Your radio has the following features IntroductionInstallation Installation OptionsThere are two ways to install the radio. You can choose Location RequirementsChecklist Gimbal Installation Recessed InstallationChange the Viewing Angle Re-position the radio then tighten the mounting knobs againInstall the Microphone Bulkhead Mount Drill the two pilot screw holes where markedHang the microphone on its mount Connect the Radio Cables GND. a ground connection is not usually requiredCompleted Installation BatteryVHF Antenna ConnectionLCD symbols and Meanings DisplayBasic Operation and Key Functions Charts Power transmission setting is incorrectComplete listing of channel charts HI or LO selection is shown on the LCDRadio Operation Scanning Features All Scan3CH Scan Favourite Channels Scan Monitor Modes Dual WatchResetting your Radio Noaa Weather ChannelsNoaa Weather Alert Appendix a Technical Specifications PLLAppendix B Troubleshooting Transceiver will not power upAppendix C Frequency Charts International Channel ChartSpecial Notes on International Channel Usage Commercial, bridge-to-bridge YesInter-ship Yes Non-Commercial YesYes 1W with Power-up US Government, Coast Guard YesEnvironmental Coast Guard Liaison YesLOW Power 1 W only Receive Only Special Notes on USA Channel UsageYes Agency Operations Commercial, Inter-ship Only YesYes Bridge 1W with power-up Canadian Coast Guard, SAR YesCanadian Coast Guard Yes Port OperationsLOW Power 1 W only Receive RX Only Special Notes on Canada Channel UsageCommercial, SAR Yes Commercial Fishing Only YesNoaa Weather Channel RX onlyCanadian Weather Channel Navico Full TWO-YEAR Eagle VHF Warranty 12000 E. Skelly DRIVE, TULSA, OK 800M. to 5 p.m. Central Standard Time, M-F Not toll-free M. to 5 p.m. Eastern Standard Time, M-FAccessory Ordering Information for all countries Page Page Page Eagle Pub Copyright