Becker Designed AR 3201 operation manual

AR 3201 - ( )

Controls and indicators	Description	Function
Channel selector	5-position rotary switch	Position A :
		When the transceiver is powerd
		up, a brief test routine is
		performed for the segments of
		the display. Afterwards the
		channel frequency 121,500 MHz
		appears in the display and the
		transceiver is ready for
		operation. In models with serial
		no. of 4000 or above, the moste
		recently set frequency instead of
		121,500 MHz.
		The setting of channel
		frequencies is performed with
		the channel selector switch in
		position A, regardless of the
		units serial number
		Position 1 through 4 :
		If is wished to store a channel
		frequency in any one of the four
		memory locations, then channel
		frequency to be stored must first
		be set with the frequency
		selector switch in position A.
		Then the desired memory
		location is selected using the
		channel selector switch, and the
		Store button is pressed.
		Stored channel frequencies
		remain in the memory even,
		when the unit is powered down
		and can be immediately called
		up again after the unit has been
		switch on.
MHz frequency selector switch	Rotary switch (continuous)	Switches the MHz steps
		indicated by the frequency
		readout.
kHz frequency selector switch	Rotary switch (continuous)	Switches the 25 kHz steps
		indicated in the frequency
		readout. The 3rd digit behind the
		point is not indicated, e.g.
		125.52 = 125.525 MHz.
Frequency indication	LC display 5 digits	When the unit switched on,
		following completion of the self-
		test routine the frequency
		appers in the display on which
		the unit is ready to operate.
		During transmission, in models
		with serial no. 4000 or above
		arrow also flashes on and off.

Page 3-2 DV 28110.03/04 Issue 02/92