Becker Designed AR 3201 operation manual Operating instructions for serial no to serial no

Page 27

AR 3201 - ( )

Controls and indicators

Description

Function

 

 

 

Store button

Pushbutton

Briefly pressing the STORE

 

 

button causes the display

 

 

frequency to be stored in one of

 

 

the four memory locations,

 

 

provided that the channel

 

 

selector switch is not in position

 

 

A, but set to one of the four

 

 

memory positions (1 - 4). In

 

 

models with serial no. of 4000 or

 

 

above the STORE button must

 

 

be held depressed for approx. 2

 

 

seconds in order for the

 

 

displayed channel frequency to

 

 

be written into the selected

 

 

memory location.

 

 

 

3.2Operating instructions for serial no. 0 to serial no. 3999

NOTE

Switch off transceiver when engines are started or stopped.

1.Switch on VHF transceiver with ON/OFF switch. For a few seconds the LC display reads 188.88 (display test). The transceiver then automatically switches to 121.500 MHz (emergency frequency) when the channel selector is in position A. When it is positioned to one of the stored channel frequencies (switch position 1-4) the display reads the stored channel frequency. To select a channel frequency other than the stored channel frequencies, position channel selector to A and then set the desired frequency by means of the MHz and kHz frequency selector switches.

2.Set to frequency of local ground station and position VOL control to center position.

3.Operate PTT key and call ground station. For optimum intelligibility keep microphone almost touching lips.

4.On response from the ground station adjust for desired volume using VOL control.

5.Position ON/OFF switch to SQL to suppress weak input signals and input noise.

6.The sidetone volume can be adapted to the noise level of the aircraft by means of the sidetone volume control.

3.3Operating instructions serial no. 4000 upwards

NOTE

Switch off transceiver when engines are started or stopped.

1.Use the ON/OFF switch to turn on the VHF transceiver. For a few seconds, the digits 188.88 will appear in the LCD (display test), as well as an arrow to indicate transmission mode. Afterwards the VHF transmitter automatically switches to the most recently set frequency, if the channel

DV 28110.03/04 Issue 02/92

Page 3-3

Image 27
Contents VHF Transceiver Installation and Operation R S T I S S U E a N D C H a N G E S Table of contents Blank Purpose of equipment IntroductionGeneral description Variants survey Channel Deg Celsius Fahrenheit Transceiver ARReceiver specifications Specifications General data TransceiverTransmitter specifications Accessories Optional functionsCertification Software Scope of deliveryInstallation Blank Visual inspection Mechanical installation of a temperature sensorGeneral Pre-instailation check GeneralMicrophone connection Installation wiring GeneralPanel lighting Speaker/headphones connectionView showing components side of audio module IC connectionAuxiliary audio input Auxiliary audio input optional standard as of module NoDimensions of VHF transceiver Aircraft wiring Wiring diagram AR 3201 with Speaker Junction Ground testing with engine on Testing after installation Ground testing with engine OFFSection Operating Instructions Blank Section Operating Instructions Control and IndicatorsPage Operating instructions serial no upwards Operating instructions for serial no to serial noStoring frequencies No channel frequency storage Optional temperature, voltage measurementLC display blinking IC operationPrecautions