Pioneer DEH-P5800MP Installation, DIN Front/Rear-mount, DIN Front-mount, Removing the unit Fig

Connecting the Units <ENGLISH>

Installation <ENGLISH>

7When using a Subwoofer without using the optional amplifier

IP-BUS input

(Blue)

Rear output

This product 15 cm (5-7/8 in.)

Front output

Subwoofer output
		Jack for the Wired Remote Control Adaptors
Antenna jack	Fuse (10 A)	Please see the Instruction Manual for the
		Wired Remote Control Adaptors (sold separately).

Note:

• Before making a final installation of the unit, tem-

porarily connect the wiring to confirm that the con-

nections are correct and the system works

properly.

• Use only the parts included with the unit to ensure

proper installation. The use of unauthorized parts

can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifications

of the vehicle.

• Install the unit where it does not get in the driver’s

way and cannot injure the passenger if there is a

sudden stop, like an emergency stop.

• The semiconductor laser will be damaged if it

•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 4)

60°

Removing the unit (Fig. 6) (Fig. 7)

Frame

To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)

•It becomes easy to remove the frame if the front panel is released.

IP-BUS cable	Multi-CD player
	(sold separately)

overheats, so don’t install the unit anywhere hot

— for instance, near a heater outlet.

Fig. 4

Fig. 6

Yellow/black

If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections.

Yellow

Blue/white

To system control terminal of the power amp or Auto-antenna relay control terminal (max. 300 mA 12 V DC).

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.

To terminal always supplied with power regardless of ignition switch position.

Red

To electric terminal controlled by ignition switch (12 V DC) ON/OFF.

Orange/white

To lighting switch terminal.

White	Gray	+
+
Front speaker
≠	Gray/black	≠
White/black
Left

Front speaker

Right

Installation with the rubber bush (Fig. 5)

Dashboard

182

Holder

After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)

Fig. 7

Black (ground)

To vehicle (metal) body.

+	Green	Violet	+
Subwoofer
≠	Green/black	Violet/black	≠

Subwoofer

53

Rubber bush

Screw

Note:

Change the initial setting of this unit (refer to the Operation

Manual). The subwoofer output of this unit is monaural.

Fig. 3

Fig. 5