Pioneer PDR-W839 manual Setting the silence threshold, Manually numbering tracks, Start recording

5 Recording Features

MENU/

DELETE

4 ¢￿

ENTER

REC

THIS

￿×óBÀöù²/

COMPACT DISC RECORDER / MULTI-CD CHANGER

3-COMPACT DISC MULTI CHANGER

COMPACT DISC DIGITAL RECORDER

MENU/

DELETE

¦￿ REC VOL

41 Á¢￿

PUSH ENTER

CD TEXT LegatoLinkConversion

Setting the silence threshold

If you're recording from CD, MD, DCC or DAT, you can usually let the recorder number the tracks automatically as they change on the source material. When recording other digital or analog sources, the recorder will start a new track if it detects more than 2 seconds of silence before the next sound on the source. However if you’re recording a noisy vinyl record or a classical recording with long quiet sections, the recorder may not always recognize the gap between tracks. For this reason you can adjust the level of sound that the recorder regards as “silence”.

Each input (analog, coaxial, and optical) has its own threshold level, which can be set independently.

Note: The minimum analog threshold level is -66dB.

1Press MENU/DELETE.

2Turn the jog dial (4 and ¢ on the remote) until A.LVL. appears in

the display, then press to ENTER.

The display shows the current “silence” threshold for automatic track numbering. The default is -54dB.

3Turn the jog dial (4 and ¢ on the remote)to change the threshold

level.

-78dB to -66dB Ð Use these levels if you find the recorder is putting in new track numbers during very quiet sections of classical music, for example.

-60dB to -48dB Ð A ‘mid’ level suitable for most recordings.

-42dB to -24dB Ð If the recorder is not putting in new track numbers because the original source is too noisy.

4Press the jog dial (ENTER) to confirm the new level.

Manually numbering tracks

Although automatic track numbering is the default mode of the recorder, you can number tracks manually as recording is taking place. In some cases—such as recording from digital satellite or Laserdisc, or from an analog source—auto track numbering may not work reliably (in these cases, a new track is started after the recorder detects 2 seconds of silence before the next sound on the source), and it's better to use manual track numbering.

Remember: It is not possible to edit track numbers after recording.

1Make sure automatic track number-

ing is switched OFF.

See Automatically numbering tracks on page 27 to switch it off.

2Start recording.

You can use manual numbering in any record mode, but it is best suited to manual digital-input or analog-input recording (see page 42 for more on these recording modes).

3Press Á¢ on the CD-R side(¢ on the remote) at any point you want

a new track to start.

CD tracks must be at least four seconds long—the recorder won't let you start a new track less than four seconds into the current track.

28

En