Icom IC-V8 instruction manual Offset frequency, Using SET Mode

REPEATER OPERATION 5

■Offset frequency

USING SET MODE

When communicating through a repeater, the transmit frequency is shifted from the receive frequency by an amount determined by the offset frequency.

qPush [8•SET] after pushing [A•FUNC]

to enter SET MODE.	F SKIP
	AO MR
w Push [Y]/[Z] several times until “±”
and offset frequency appear.

eRotate [VOL] to select the desired offset frequency.

D TX

75

50 LM 25

•Selectable steps are the same as the pre-set tuning steps.

•The unit of the displayed offset frequency is “MHz.”

rPush [#•ENT ] to fix the offset frequency and exit SET MODE.

■ Subaudible tones
	USING SET MODE

Some repeaters require subaudible tones to be accessed. Sub- audible tones are superimposed over your normal signal and must be set in advance.

q Push [8•SET] after pushing [A•FUNC]	F SKIP	TX
to enter SET MODE.
	AO MR
		75
w Push [Y]/[Z] one or more times until
		50 LM
“rt” appears.		25

eRotate [VOL] to select the desired subaudible tone.

rPush [#•ENT ] to enter the selected tone and exit set mode.

Available subaudible tone frequencies								(unit: Hz)
67.0	79.7	94.8	110.9	131.8	156.7	171.3	186.2	203.5	229.1
69.3	82.5	97.4	114.8	136.5	159.8	173.8	189.9	206.5	233.6
71.9	85.4	100.0	118.8	141.3	162.2	177.3	192.8	210.7	241.8
74.4	88.5	103.5	123.0	146.2	165.5	179.9	196.6	218.1	250.3
77.0	91.5	107.2	127.3	151.4	167.9	183.5	199.5	225.7	254.1

22