Icom IC-F110 instruction manual Supplied Accessories

Page 17

q ANTENNA CONNECTOR

CONNECTION AND MAINTENANCE 4

■Supplied Accessories

Connects to an antenna. Contact your dealer about an- tenna selection and placement.

w MICROPHONE HANGER

Connect the supplied microphone hanger to the vehicle’s ground for microphone on/off hook functions. (See p. 2)

e DC POWER RECEPTACLE

Connects to a 12 V DC battery. Pay attention to polarities. NEVER connect to a 24 V battery. This could damage the transceiver.

r OPTIONAL CABLE (OPC-617)

q w e

r

	y	u
		u
		i
		o
!0	!1	!2

t

KEY-STICKER

Connect an external modem unit, dimmer control, etc.

t EXTERNAL SPEAKER JACK

Connect a 4–8 Ω external speaker, if desired.

q Microphone

1

wMicrophone hanger and

screw set

1 set

eMicrophone hanger cable . 1 r DC power cable (OPC-1194)

............................................1

tFunction name stickers*

(KEY STICKER)

1

*Function name stickers

y Mounting bracket	1
u Bracket bolts	4

iMounting screws (M5⋅12) . 4 o Self-tapping screws (M5⋅20)

...........................................	4
!0Flat washers	4
!1Spring washers	4
!2Nuts	4

There are no names on the programmable function keys since the functions can be freely assigned to these keys.

Attach the supplied function name stickers above the appropriate keys for easy recognition of that key’s assigned function.

14

Image 17

Contents IF110 May occur For the IC-F110 VHF Transceiver and IC-F210 UHF TransceiverEquipment damage may occur If disregarded, inconvenience only. No riskTable of Contents Front panel Panel DescriptionFunction display Programmable function keys 5TONE IndicatorAlphanumeric Display ¡ CH UP and Down Keys¡ Scan TAG KEY ¡ Scan START/STOP KEY¡ Priority Channel Keys ¡ Operating Channel Keys¡ Call KEY ¡ Output Power Selection Keys¡ Talk around KEY ¡ WIDE/NARROW KEYMode. Please refer to p ¡ User SET Mode KEY¡ Scrambler KEY Channel selection Turning power onOperation Transmitting notes Receiving and transmittingReceiving TransmittingTX code number selection TX code channel selectionDtmf transmission Scrambler functionAvailable set mode functions User set mode SmarTrunk II operation SmarTrunk II and conventional modes Placing a telephone call Calling another local system subscriberLast number re-dial Terminating a callMemory speed-dialling Turbo SpeeDial12V Battery Connection and MaintenanceRear panel and connection BlackSupplied Accessories Mounting the transceiver Optional UT-105, UT-108 or UT-111 installationOptional OPC-617 installation Optional UT-109 or UT-110 InstallationInstall the OPC-617 as shown below Replace the bottom cover and screwsAntenna Fuse replacementCleaning HM-100TN OptionsSM-25 UT-105 SmarTrunk Iitm Logic Board0168 Kind of equipment UHF Transceiver Type-designation iC-f210 Kamiminami, Hirano-ku, Osaka 547-0003 Japan Intended Country of Use

Related manuals

Manual 24 pages 42.95 Kb