Terminating a call, Last number re-dial

DTerminating a call

After completing a call, push [#] to disconnect (hang up).

IMPORTANT!: If one person in the conversation termi- nates a call, all participants will be cut off.

DLast number re-dial

Push [M] 2 times to automatically re-dial the last called num- ber.

• A high-pitched beep indicates that the number is accepted.

DMemory speed-dialling

To automatically dial a commonly used number from memory:

• Push [M] followed by the memory location (0–9).

DTurbo SpeeDial

To automatically dial a commonly used number with one push:

• Push one of the turbo SpeeDial keys ([A], [B], [C] or [D]).

DProgramming memory speed dial

qPush and hold [M] until you hear a high-pitched beep.

w Enter the memory location (0–9, A, B, C, D), the telephone or subscriber number, then [1], [M] (or [3], [M] if for another system subscriber).

•A high-pitched beep indicates successful programming.

•Memories [A]–[D] are used for the Turbo SpeeDial.

OPTIONAL SmarTrunk II™ OPERATION 3

DSystem busy indication

If all channels are busy, three low beeps sound after you initi- ate a call. Try the call again later.

DPTT dispatch operation

qPush [PTT] once (without dialling) to initiate a dispatch call. w Begin talking after you hear three beeps (one short, high-

pitched, two very-short, low-pitched).

e Receiving a dispatch call is indicated by the same three- beep sequence.

•It is not necessary to push [M] to answer a dispatch call.

DEmergency call

Push [0], [M] to initiate an emergency call.

• Contact your dealer for details.

DClear channel alerting

If all channels are busy, the transceiver automatically begins searching for an open channel and beeps every ten seconds. When two short beeps (low-pitched, then high-pitched) are heard, a channel is available. Push [M] two times immediate- ly to re-dial the last number.

NOTE: For additional operating instructions, contact your dealer.