Manuals / Verona / Kitchen Appliance / Range

Verona VEFSGG 365 N warranty Pressure Regulator Installation, Lock, Arrow, 2a, 2b

Models: VEFSGG 365 N

1 28

Download 28 pages 1.47 Kb

Page 14

Image 14



PRESSURE REGULATOR INSTALLATION

STEP 1

Mount the 1/2” NPT (conical) male connector to the pressure regulator and tighten by using a wrench.

Do not over tighten the connector. Over tightening may crack regulator.

LOCK

Arrow

Fig. 2.2a

STEP 2

Assemble the 1/2” NPT connector + pressure regulator group to the extension pipe interposing the gasket supplied. The regulator cover must be ordiented toward the front side of the range.

IMPORTANT: use two spanners to tighten the connection.

Regulator cover

Fig. 2.2b

Page 14

Image 14

Verona VEFSGG 365 N warranty Pressure Regulator Installation, Lock, Arrow, 2a, 2b

Contents

IMPORTANT - PLEASE READ AND FOLLOW INSTALLATION INSTRUCTIONSfor residential use only FOR INSTALLER ONLYSEE INSTALLATION INSTRUCTIONS WHAT TO DO IF YOU SMELL GASINSTALL ANTI-TIP DEVICE PACKED ALL RANGES CAN TIPDATA PLATE CONVERSION LABEL INSTALLATION INSTRUCTIONS TOOLS NEEDED FOR INSTALLATIONELECTRICAL GROUNDING INSTRUCTIONS GENERAL INFORMATIONREPLACEMENT PARTS 10. Electrical Requirement installation PROXIMITY TO SIDE CABINETSGAS AND ELECTRIC CONNECTION Fig. 1.20 0 mm 0 0 mmPROXIMITY TO SIDE CABINETS RANGE WITH BACKGUARD0 mm 0 mm20 min PROXIMITY TO SIDE CABINETSMOVING THE COOKER FITTING THE ADJUSTABLE FEETLEVELLING THE COOKER Fig. 1.7aOR THE ISLAND TRIM It is mandatory to install theASSEMBLING THE BACKGUARD backguard or the island trim5 mm ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS5 mm YOU MUST USE STABILITY ANTI TIP BRACKET TO PREVENT UNIT FROM TIPPING1. Manual Shut-off Valve fig. 2.1 gas connectionUse a new CSA or UL approved gas supply line Install a shut-off valve 2. Pressure RegulatorLOCK PRESSURE REGULATOR INSTALLATION STEP 1STEP 2 ArrowFig. 2.2c STEP 3STEP 4 Fig. 2.2dSTEP 5 Fig. 2.2eManifold male GAS CONNECTION SPECIFICATIONConnector pipe fitting4. Rigid Pipe Connections 5. Leak Testing3. Flexible Connections To set the pressure regulator SETTING THE PRESSURE REGULATOR fig. 2.5CONVERSION TO LP/PROPANE GAS Semi-rapid burner OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING THE INJECTORSINJECTORS TABLE Triple ring burnerInside crown of DUAL burner SETTING THE BURNER MINIMUMSemirapid and triple ring burners Outside crowns of DUAL burnera Oven Burner b Broil BurnerADJUSTMENT OF THE OVEN BURNER MINIMUM N.B. For LP/PROPANE gas the by-pass screw must be fixed thoroughlyVERY IMPORTANT electrical connectionRecommended ground method Fig. 3.1WIRING DIAGRAM Page Page Cod. 1104634 - ß1