Manuals / Verona / Kitchen Appliance / Range

Verona VEFSGG 365 N warranty Anti-Tip Stability Device Installation Instructions, 5 mm

Models: VEFSGG 365 N

1 28

Download 28 pages 1.47 Kb

Page 12

Image 12



YOU MUST USE STABILITY ANTI TIP BRACKET TO PREVENT UNIT FROM TIPPING.

ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS

1.The anti-tip bracket has to be attached as shown on figure below, it has to be fixed on the rear wall by no. 2 (two) suitable screws (supplied with the anti-tip kit).

2.After fixing the anti-tip bracket, slide range into place. Be sure the anti-tip bracket is fully inserted in the slot of the range back.

ANTI-TIP STABILITY DEVICE FIXING

Anti-tip stability device

17"	15/16

.5 mm)
(455

26" 11/16 (678 mm) from top of cooktop with range installed in final position

17"	15/16

.5 mm)
(455

Dotted line showing the position of the range when installed

Slot for inserting the anti-tip bracket

Fig. 1.10

Page 12

Image 12

Verona VEFSGG 365 N warranty Anti-Tip Stability Device Installation Instructions, 5 mm

Contents

INSTALLATION INSTRUCTIONS for residential use onlyIMPORTANT - PLEASE READ AND FOLLOW FOR INSTALLER ONLYWHAT TO DO IF YOU SMELL GAS INSTALL ANTI-TIP DEVICE PACKEDSEE INSTALLATION INSTRUCTIONS ALL RANGES CAN TIPDATA PLATE CONVERSION LABEL INSTALLATION INSTRUCTIONS TOOLS NEEDED FOR INSTALLATIONGENERAL INFORMATION REPLACEMENT PARTSELECTRICAL GROUNDING INSTRUCTIONS 10. Electrical Requirement installation PROXIMITY TO SIDE CABINETSGAS AND ELECTRIC CONNECTION Fig. 1.20 0 mm PROXIMITY TO SIDE CABINETS0 0 mm RANGE WITH BACKGUARD0 mm 20 min0 mm PROXIMITY TO SIDE CABINETSFITTING THE ADJUSTABLE FEET LEVELLING THE COOKERMOVING THE COOKER Fig. 1.7aIt is mandatory to install the ASSEMBLING THE BACKGUARDOR THE ISLAND TRIM backguard or the island trimANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS 5 mm5 mm YOU MUST USE STABILITY ANTI TIP BRACKET TO PREVENT UNIT FROM TIPPINGgas connection Use a new CSA or UL approved gas supply line Install a shut-off valve1. Manual Shut-off Valve fig. 2.1 2. Pressure RegulatorPRESSURE REGULATOR INSTALLATION STEP 1 STEP 2LOCK ArrowSTEP 3 STEP 4Fig. 2.2c Fig. 2.2dSTEP 5 Fig. 2.2eGAS CONNECTION SPECIFICATION ConnectorManifold male pipe fitting5. Leak Testing 3. Flexible Connections4. Rigid Pipe Connections SETTING THE PRESSURE REGULATOR fig. 2.5 CONVERSION TO LP/PROPANE GASTo set the pressure regulator OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING THE INJECTORS INJECTORS TABLESemi-rapid burner Triple ring burnerSETTING THE BURNER MINIMUM Semirapid and triple ring burnersInside crown of DUAL burner Outside crowns of DUAL burnera Oven Burner b Broil BurnerADJUSTMENT OF THE OVEN BURNER MINIMUM N.B. For LP/PROPANE gas the by-pass screw must be fixed thoroughlyelectrical connection Recommended ground methodVERY IMPORTANT Fig. 3.1WIRING DIAGRAM Page Page Cod. 1104634 - ß1

YOU MUST USE STABILITY ANTI TIP BRACKET TO PREVENT UNIT FROM TIPPING.

ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS

.5 mm)

Fig. 1.10